Network Reset [Nwr]; Wireless Setup [Wis] - Canton Smart Soundbar 10 Bedienungsanleitung

English
Note: If the connection type is set from wireless [WIF] to wired [ETH], the WiFi connection turns off automatically.

Network Reset [NWR]

With this function you can delete reset all network settings stored on the Soundbar 10 and reset the Soundbar to the factory settings.
Caution: All settings you have made and stored on the Soundbar's WiFi module, including the settings from Chromecast built-in resp. AirPlay, will
be deleted!
To perform the reset, please do as follows:
Power up the Soundbar 10 by pressing the Power button " " on the remote.
1
To enter the menu, press the "M" button.
2
Use the " " or " " button to navigate into the menu Network Setup [NWS] and confirm with the "OK" button.
3
Use the " " or " " button to select the funktion Network Reset [NWR] and confirm with the "OK" button.
4
The menu shows the Network Reset menu and the item "No" is selected, the display shows [NO].
If you want to cancel the reset precedure, press the "OK" button or press the "M" button.
5
If you want to perform the reset, select "Reset All" using
6
The OSD shows "Please Wait", the display still shows [YES]. After the reset-process (ca. 30-40 seconds) the Soundbar 10 goes back into normal
7
mode. The WiFi module reboots. During the starting process the LED flashes green rapidly.

4. Wireless Setup [WIS]

The fourth item of the Main Menu is the Wireless Setup which contains all settings of the integrated wireless audio module and
Bluetooth wireless technology. It contains the items:
®
• Wireless Pairing [WSP]
• Wireless Reset [WRE]
• RF Power [TXP]
• RF Channel [CHN]
• Bluetooth [BT]
- Pair Mode [BTP]
106
- BT Select [BTS] - Bluetooth Reset [BRE]
" " or " " button and press the "OK" button. The display shows [YES].
- Autoplay [ATP]