Ir Menu [Irm]; Ir Learn [Irl] - Canton Smart Soundbar 10 Bedienungsanleitung

English
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
2
Select the menu Sleep Timer [SLP] and press the "OK" button to confirm.
3
Select the desired time using the "+" or "–" keys.
4
Press the "M" button to exit this menu item.
5
Note: The Sleep Timer will be disabled automatically after a power down. That means the shut down time must be selected after every
power up sequence.
IR Menu [IRM]
This menu includes all functions relevant for the infrared (IR) operation of the Soundbar 10 using a TV- resp. universal-remote.

IR Learn [IRL]

The Soundbar 10 can learn the infrared codes of an infrared-remote (TV- or universal remote control) and therefore allows you to control the
functions of the Soundbar 10 and another device resp. other devices with one remote control. You can allocate any key of the TV-/universal
remote control to your Soundbar 10. When choosing a key, make sure that the commands for the Soundbar 10 are not in conflict with the other
devices.
To learn the IR codes of a third party remote, hold the TV-/universal-remote control in position and do the following steps:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
2
Select the IR Menu [IRM] and press the "OK" button to confirm.
3
Choose the function IR Learn [IRL] and press the "OK" button to confirm.
4
[IRL] is flashing in the display. On the screen "Press the key you want to learn" is displayed.
5
Press the wanted function on the Canton Smart remote control e.g. "+" for Volume +.
6
Now the display shows the chosen function, e.g. "V+" or "Please press new button" and "Volume+" in the OSD.
7
Within 15 seconds, press the key you wish to allocate to this function on the TV-/universal-remote.
8
Once the IR command has been successfully allocated, the display shows [OK] resp. the OSD shows "Success" and you can continue with
9
the programming of the next function, e.g. "Volume -".
If the display shows [FAI] the allocation has failed and you need to repeat steps 6 to 9. Please try a lower or higher distance between the
8
Soundbar and the TV-/universal-remote control in case the process fails again. Alternatively, try to press the key on the TV-/universal-remote
shorter or longer.
To exit the IR Learn [IRL] menu, press and hold the "M" button for 3 seconds. After one minute without input, the system automatically
9
returns to the IR menu [IRM].
94
Notes: • The red "On/Standby" key on the remote control has a dual function. Press it once and the display shows [ON] which allows the swit