Direct Input Learn [Dil] - Canton Smart Soundbar 10 Bedienungsanleitung

ching on function to be programmed. If the red "On/Standby" key on the Canton remote control is pressed twice in quick sequence,
the display shows [STB] and the Standby resp. switching off function can be learned. If your TV-/universal-remote control has only
one key for the "On" and "Off" functions, both the "On" and "Standby" functions must still be allocated with this command.
• Due to the variety of infrared codes it is not possible to guarantee that every IR remote control signal can be learned by the Smart
Soundbar 10.
• Signals from radio frequency (RF) remote controls cannot be learned, in general!

Direct Input Learn [DIL]

This function allows you a direct selection of the signal inputs if using a third party TV-/universal-remote control. In addition to the "serial" selec-
tion of the inputs using the " " and " " keys, you can directly select the signal inputs (e.g. TV / [ARC]) when using your TV or universal remote
control. That means you can allocate the desired input to a key on your remote control.
Learnable inputs: HDMI input 1-3 [HD1-HD3], HDMI
®
[NET] and Bluetooth
To learn the relating IR codes, hold the TV / third party remote control in position and do the following steps:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
2
Select the IR Menu [IRM] and press the "OK" button to confirm.
3
Choose the function Direct Input Learn [DIL] and press the "OK" button to confirm.
4
The OSD shows "Press the new button" and [HD1] is flashing on the display and "BDP" is displayed on the screen for the first HDMI input.
5
You can now assign the BDP [HD1] input to a button on your TV-/universal-remote control.
Note: If you press this key on the remote control while the Soundbar 10 is in normal mode, the Soundbar 10 switches directly to the input [BDP],
independent of the current input.
Press the desired key on the TV-/universal-remote control. If the infrared code has been successfully stored by the system, [OK] is shown
6
briefly in the display resp. "Success" on the screen, followed by the next input SAT [HD2].
If the code could not be learned, [FAI] appears briefly on the display resp. FAIL appears on the screen to indicate that no code has been sto-
7
red. In this case, [HD1] will still be displayed. In this case the system jumps back into the IR Menu to the item Direct Input Learn [DIL]. Please
increase or decrease the distance between the Soundbar 10 and the TV-/Universal remote and repeat the process. Alternatively you can try
to press the buttons of the TV-/universal remote longer or less long.
output [ARC], optical input [OPT], coxial input [COX], analog input [LIN], network input
®
input [BT]
®
English
3 9 5