SunFounder Da Vinci Kit Bedienungsanleitung Seite 366

SunFounder Da Vinci Kit
MORSECODE = {
'A':'01', 'B':'1000', 'C':'1010', 'D':'100', 'E':'0', 'F':'0010', 'G':'110',
'H':'0000', 'I':'00', 'J':'0111', 'K':'101', 'L':'0100', 'M':'11', 'N':'10',
'O':'111', 'P':'0110', 'Q':'1101', 'R':'010', 'S':'000', 'T':'1',
'U':'001', 'V':'0001', 'W':'011', 'X':'1001', 'Y':'1011', 'Z':'1100',
'1':'01111', '2':'00111', '3':'00011', '4':'00001', '5':'00000',
'6':'10000', '7':'11000', '8':'11100', '9':'11110', '0':'11111',
'?':'001100', '/':'10010', ',':'110011', '.':'010101', ';':'101010',
'!':'101011', '@':'011010', ':':'111000',
}
def setup():
GPIO.setmode(GPIO.BCM)
GPIO.setup(BeepPin, GPIO.OUT, initial=GPIO.LOW)
GPIO.setup(ALedPin,GPIO.OUT,initial=GPIO.LOW)
def on():
GPIO.output(BeepPin, 1)
GPIO.output(ALedPin, 1)
def off():
GPIO.output(BeepPin, 0)
GPIO.output(ALedPin, 0)
def beep(dt):
on()
time.sleep(dt)
off()
time.sleep(dt)
def morsecode(code):
pause = 0.25
for letter in code:
for tap in
if tap
beep(pause/2)
if tap
beep(pause)
time.sleep(pause)
def main():
while True:
code=input("Please input the
code = code.upper()
print(code)
morsecode(code)
def destroy():
print("")
GPIO.output(BeepPin, GPIO.LOW)
GPIO.output(ALedPin, GPIO.LOW)
GPIO.cleanup()
if __name__ == '__main__':
setup()
try:
362
# dt for delay time.
MORSECODE[letter]:
== '0':
== '1':
messenger:")
(Fortsetzung der vorherigen Seite)
(Fortsetzung auf der nächsten Seite)
Kapitel 1. Über das Da Vinci Kit