Abicor Binzel iCAT mini Betriebsanleitung Seite 56

6 Commissioning
6.5.2 Mounting the welding torch neck ABIROB
NOTICE
• The torch neck for the wire brake must be equipped with the neckliner intended for this
purpose. The neckliner used depends on the wire diameter and the welding torch
geometry.
• Consult the documentation for the welding components.
1
1 Protective cap
2 ABIROB
3 Neckliner
Fig. 11
1 Equip the welding torch neck ABIROB
2 Insert the neckliner (3) in the torch neck until it stops.
3 Loosen the cylinder head screw (8).
4 Mount the welding torch neck ABIROB
welding torch must be inserted all the way into the welding torch interface (4).
5 Tighten the cylinder head screw (SW4) with a max. tightening torque of M=6 Nm to fix the
welding torch.
EN - 22
2
4 Welding torch/cable
®
G torch neck assembly interface
5 Wire brake
Mounting the welding torch neck ABIROB
®
G (iCAT mini with wire brake)
3 4
6 iCAT mini
7 Bellows
8 Cylinder head screw M5 × 16
®
G (iCAT mini with wire brake)
®
G (2) with tip adaptor, contact tip, and gas nozzle.
®
G (2) in the welding torch interface (4). The
iCAT mini
5
6
7
8
BAL.0361.0 • 2021-02-25