Abicor Binzel iCAT mini Betriebsanleitung Seite 57

iCAT mini
NOTICE
• Do not tighten the cylinder head screw (8) without a mounted welding torch.
6 Put the protective cap (1) back on.
6.5.3 Mounting the welding torch neck ABIROB
NOTICE
• Check all connections and sealing rings regularly for damage and to ensure they are
secure. Replace as needed.
• Consult the documentation for the welding components.
1 Welding torch neck
ABIROB
2 Positioning pin for
torch orientation
Fig. 12
1 Equip the welding torch neck ABIROB
gas nozzle.
2 Insert the positioning pin (2) in the hole (4) at the welding torch/cable assembly
interface (3). The welding torch neck ABIROB
position only.
3 Using the connection nut (5), screw the welding torch neck ABIROB
torch/cable assembly interface (3).
BAL.0361.0 • 2021-02-25
1 2
3 Welding torch/
®
W cable assembly
interface
Mounting the welding torch neck ABIROB
®
W
3
4 Hole for
positioning pin for
torch orientation
®
W
®
W (1) with tip adaptor, contact tip, and
®
W (1) may be attached in this
6 Commissioning
4
5
5 Connection nut for
welding torch
®
W (1) to the welding
EN - 23