Scheppach Molda 7.0 Dokumentation Seite 48

Fig. "T"
Moulding the front face
Push the workpiece along the milling fence using
the safety pressure device and the guide rails.
With a push piece, an exactly rectangular surface
related to the longitudinal side can be produced.
(The push piece made of wood must be prepared by
the customer himself.)
Fig. "U"
Insert moulding
For insert moulding, the milling fence and the
table length extension with cross stop must be
used.
Table length extension (optional equipment Order
no. 7324 0170).
Fig. "V"
Slot and shank milling work
The following equipment is required for slot and
shank milling work:
• Milling fence with guard
• Sliding table carriage with slot milling guard
Eccentric clamping device
•
Fig. "W"
Moulding of curved workpieces
For moulding curved workpieces, the curved
moulding fence and the pertaining curved fence
plates must be used.
1902104852
Fig. "T"
Fig. "U"
Fig."V"
Fig."W"
Documentation
Page 49