Scheppach Molda 7.0 Dokumentation Seite 44

Fig. "M"
Moulding spindle adjustment
!!Attention!!
Always switch off the motor and wait for the rotating
tool to completely stop before adjusting the moulding
spindle!
Spindle height adjustment: 100 mm
• The height adjustment is done with the hand wheel
(1).
• Release the spindle brake on the clamping handle
(2) and make the height adjustment with the hand
wheel (1).
• One mark on the scale plate is 0.1 mm. One revo-
lution of the hand wheel is 2 mm.
• After setting the tool height, firmly tighten the
clamping handle (2).
• Always carry out test moulding runs and
measure the workpiece again!
Spindle tilting adjustment from +45° to -5°
• Like the height adjustment, the tilting angle is ad-
justed with the hand wheel (1).
• Release the clamping handle (3).
• Pull out the hand wheel (1) with both hands and
set the tilting angle with the hand wheel (1).
• Once the setting completed, firmly tighten the
clamping handle (3).
• For resetting to 0° , turn the hand wheel back to the
limit stop.
For swinging over (-5° ), tilt the spindle to approx. 15° ,
move the ball button (4) downwards and swing back.
Tighten the clamping handle.
Fig. "N"
Note
• The machine cover on the back must be correctly
closed and the handle turned in, in order to be able
to start the machine.
• Put the main switch to "1".
• Put the reversing switch (2) to "left" or "right". (At
the position "right", the yellow pilot lamp lights up.)
Engage the motor switch (3) with the green button.
1902104852
Fig. "M"
Fig. "N"
Betriebsschalter
Documentation
Drehzahlanzeigelampen
1
1
2
2
!
Achtung
Rechtslauf
Wendeschalter
grüner Sicherheitsknopf
Page 45