Jackle JESS WELDING inoMIG 350 Betriebsanleitung Seite 84

13 Welding torch with display
13 Welding torch with display
NOTICE
Only replace the torch when the machine is switched off.
13.1 Functions (sorted by control box)
Tab. 7
Functions sorted by control box
Hnd Cor Sol
■ ■ ■*
MC1
■ ■ ■*
MC2
Tab. 8
Abbreviatio
n
Hnd
Cor
Sol
Mod
Cho
Sts
bUb
PrG
PoG
Job
CSC
CEC
SPt
EN - 30
Mod Cho Sts
■ ■ ■
■ ■ ■
 * This function is active during welding.
Description of abbreviations from Tab. 7 on page EN-30
Description
Manual mode
Voltage adjustment (automatic mode)
Power
Mode (see 14.1 on page EN-31)
Throttle strength
Start speed
Burn back
Gas pre-flow time
Gas post-flow time
Job (see 14.2 on page EN-31)
Crater start current
Crater end current
Spot time
 CSC and CEC are only active when the crater function is used
Tap the arrow button to switch between the individual functions. You can use the
"+" and "−" buttons to change the value. The changes are displayed
simultaneously on the MC control box
bUb PrG PoG Job
■ ■ ■ ■
■
inoMIG 350/400/500
CSC CEC SPt
■ ■ ■
■
BA-0014 • 2020-06-05