Jackle JESS WELDING inoMIG 350 Betriebsanleitung Seite 77

inoMIG 350/400/500
10.3 Automatic/manual mode (MC1–2)
Press and hold the material button (for more than 1 second) to switch between automatic and manual mode.
In automatic mode, all parameters required for welding are set and maintained automatically by the control
system. In manual mode, you can use the left knob to set the wire feeder speed in m/min and, if necessary,
use the middle knob to set the power (with these two settings being independent of one another).
10.4 Power pre-selection/material thickness (MC1–2)
When using the MC1–2 control systems, the welding power can be adjusted using the knob in the middle.
In automatic mode, the wire speed, throttle and welding current are always adjusted at the same time. It is
also possible to display the material thickness instead of the welding current. To do so, simply tap the mm
(MC1) or
required material thickness using the middle knob (MC1) or the
10.5 Arc length adjustment (AUTO)
The arc length can be adjusted for special welding tasks. You can turn the left button to decrease or increase
the arc length by 3 V around the current operating point (in increments of 0.1). The change from −3.0 V to
+3.0 V is shown in the left-hand display. The new welding current is displayed synchronously in the middle
display. The wire feeder speed remains constant throughout and is never changed. During welding, the
symbols "−" or "+" are shown in the middle display to indicate whether a lower └ or higher
voltage is set. No symbol is visible at the normal operating point.
10.6 Fx functions (MC1)
In idle mode (when not welding). Briefly tap the Fx operating button to set the following functions for each
individual welding curve:
10.7 MIG operating mode
Throttle (Cho)
Start speed (StS)
Wire burn-back (bUb)
Gas pre-flow time (PrG)
Gas post-flow time (PoG)
*Crater hotstart current (CSC)
*Crater hotstart time (tCSC)
*Crater filling end current (CEC)
*Crater end time (tCEC)
*Slope-down speed (SLO)
Spot time (SPt)
Code (CODE)
NOTICE
*MC1 only if crater filling (LED S) is active
10.8 Electrode operating mode
Hotstart (HSt)
Arc force (Arcf)
BA-0014 • 2020-06-05
►
(MC2) button until the mm LED or the material thickness icon illuminates. You can then set the
▲ ▼
buttons (MC2).
Continuous adjustment of the welding choke in the range
+15 (softer) to −15 (harder) with "0" as standard
10% to 100% of the welding speed
−60 ms (long, tip) to +90 ms (short, ball at wire end)
0.0 to 1.0 seconds
0.5 to 10 seconds
−50% to +100% of the current welding current
0.1 to 5.0 seconds
−100% to +50% of the current welding current
0.1 to 5.0 seconds
1 volt/second (slow) to 20 V/s (fast)
0.5 to 10 seconds
For locking the control system (see 10.15 on page EN-24)
0 to 150% of the welding current
100 to 250% of the welding current
10 Operation/welding
┌
welding
EN - 23