Material Table - Jackle JESS WELDING inoMIG 350 Betriebsanleitung

inoMIG 350/400/500

19 Material table

The following materials are programmed in the control system by default:
Tab. 12 Material table
Material Display MC
Steel* St
Steel* St
Steel* St
CrNi 4316 – ER308 4316
CrNi 4576 4576
ALMG 5 ALnG
ALSi 5 ALSi
CuSi 3 CuSi
Metal flux-cored wire nEPU
T424 MC2 H5
Basic flux-cored wire bASI
T424 BC4 H5
Rutile flux-cored wire ruti
T422 PC1 H5
*Special programs (arcs) available
1. CSt: Reduced-power, cold short arc (cold steel)
Welding with a cold arc with reduced power.
Advantages: excellent gap bridging (including vertical down), low heat input, reduced distortion. Suitable
for root welds and sheet-metal welds, including in the MIG soldering process.
Material Display MC
Steel CSt
2. PSt: concentrated, high-pressure spray arcs (Power Steel)
Welding with a concentrated, high-pressure arc.
Advantages: very good root and side fusion, high welding speed, low heat input. Stable and controllable
welding arc in the upper welding power range.
Material Display MC
Steel PSt
3. rSt: Spatter-reduced short arcs (root steel):
Welding with a concentrated, high-pressure arc
Advantages: very good root and side fusion, high welding speed, low heat input. Stable and controllable
welding arc in the upper welding power range.
Material Display MC
Steel rSt
BA-0014 • 2020-06-05
Gas
Argon 82%, CO 18% – MIX 18
2
Argon 90%, CO 5%, O 5%
2 2
CO
2
Argon 98%, CO 2% – MIX 2
2
Argon 98%, CO 2% – MIX 2
2
Argon 100% (Ar)
Argon 100% (Ar)
Argon 100% (Ar)
Argon 82%, CO 18% – MIX 18
2
Argon 82%, CO 18% – MIX 18
2
Argon 82%, CO 18% – MIX 18
2
Gas
Argon 82%, CO 18% – MIX 18
2
Gas
Argon 82%, CO 18% – MIX 18
2
Gas
Argon 82%, CO 18% – MIX 18
2
19 Material table
Display MC Diameter (mm)
Ar82 0.8–1.0–1.2–1.6
Ar90 0.8–1.0–1.2–1.6
CO 0.8–1.0–1.2–1.6
2
Ar98 0.8–1.0–1.2
Ar98 0.8–1.0–1.2
Ar 1.0–1.2
Ar 1.0–1.2
Ar 0.8–1.0
Ar82 1.2
Ar82 1.2
Ar82 1.2
Display MC Diameter (mm)
Ar82 0.8–1.0–1.2
Display MC Diameter (mm)
Ar82 0.8–1.0–1.6
Display MC Diameter (mm)
Ar82 0.8–1.0–1.2
EN - 35