Jackle JESS WELDING inoMIG 350 Betriebsanleitung Seite 78

10 Operation/welding
10.9 TIG operating mode
Gas post-flow time (PoG)
Down slope (i.e. reduce current)
(dSLP)
Use the middle knob to adjust the values within their ranges. If the value is not changed for more than
2 seconds, the display switches to default and saves the value.
10.10 During welding (MIG operating mode)
During welding, you can tap on the Fx button to call up the throttle function and adjust the throttle value.
"Choc" is shown in the left-hand display, while the current value is shown in the middle display. You can now
use the middle knob to change the value in the range between −15 (hard) and +15 (soft). With welding in
automatic mode, you can tap the Fx operating button again to display the current arc adjustment. You can
then use the left knob to change the value in the range between −3.0 V and +3.0 V.
10.11 MC2 functions
Briefly tap the
10.12 MIG operating mode
Throttle
("Choc" in the display)
Start speed
Wire burn back
Tap the
seconds, the display switches to default and saves the value.
10.13 Electrode operating mode
Hotstart (HSt on the
display)
Arc force (Arcf)
10.14 TIG operating mode
Gas post-flow time
(PoG)
Down slope (i.e. reduce
current) (dSLP)
Use the middle knob (MC2) to adjust the values within their ranges. If the value is not changed for more than
2 seconds, the display switches to default and saves the value.
If you press the
Pressing the button again switches to the next parameter.
10.15 Lock control system – CODE (MC1)
Optimally configure the control system for the welding task. The control system can then be locked to prevent
third parties from changing the settings. To do this, press the Fx button until CODE appears on the display,
then use the left-hand knob to select any number between 0001 and 9999. Once the number has been set,
the control system is locked by tapping the "Drahteinfädeln" (Wire feed) button. The only functions that can
now be used are "Gastest" (Gas test), "Drahteinfädeln" (Wire feed) and "Korrektur der
Drahtgeschwindigkeit" (Wire speed correction). All other functions are locked. To unlock the control system,
tap the Fx button again until CODE appears on the display. Now use the knob to select the same number
as before and press the "Drahteinfädeln" (Wire feed) button. The control system returns to normal mode.
Note: 0000 is not permitted – no function assigned.
EN - 24
►
(D ) operating button to set the following functions for each individual welding curve:
Continuous adjustment of the welding choke in the range −80 (harder) to
+80 (softer) with "0" as standard
10% to 100% of the welding speed
−90 ms to +60 ms
▲ ▼
buttons to adjust the values within their ranges. If the value is not changed for more than 2
0 to 150% of the welding current
100 to 250% of the welding current
2 to 20 seconds
0.0 to 10.0 seconds
►
(D) operating button again, the most recently changed parameter is displayed.
2 to 20 seconds
0.0 to 10.0 seconds
inoMIG 350/400/500
BA-0014 • 2020-06-05