Operating Mode Description - Jackle JESS WELDING inoMIG 350 Betriebsanleitung

10 Operation/welding
Pos.
K
L
M
N
O
10 Operation/welding
10.1 2-/4-step, spot (MC1–2), crater filling (MC1)
You can tap on the operating button (pos. J ) to switch between 2-step, 4-step, 2-step spot (MC1–2) and
2T/4T crater filling (MC1). The activated function is indicated by the LEDs.
Fig. 16
Operating mode
2-step
4-step
10.2 Material selection (MC1–2)
When you briefly tap the material button, the material type (e.g. steel) appears on the left-hand display, the
gas (e.g. CO
can then turn the left knob to make the required material selection. The last selection shown on the display
is adopted.
EN - 22
Description
Knob for adjusting the welding power in the middle display
Knob for setting the material type, adjusting the arc length (AUTO-(I)), setting the wire speed in
m/min (HAND-(I)), and changing all values in the left-hand display
Operating button for switching between 2-step, 4-step and 2-step spot (tap)
LED indicator showing whether 2-step, 4-step or 2-step spot is active
Display of wire speed in m/min (HAND-(I)) or adjustment of the arc length in the range −3.0 V
to +3.0 V (AUTO-(I)), flashing dot: HOLD function active
Crater filling program MC1 (Led S)
Description
Press the torch trigger and the arc is ignited after the gas pre-flow time (PrG) with
the pre-defined hotstart current (CSC). Once the hotstart time (tCSC) has ended,
the welding current drops to the pre-defined welding at slope-down speed
(SLO). Release the torch trigger and the welding current drops to the pre-defined
crater end welding current (CEC) at slope-down speed (SLO). Once the end
crater time (tCEC) ends, the arc is extinguished. The shielding gas continues to
flow for the set time (PoG).
Press the torch trigger and the arc is ignited with the pre-defined hotstart current
(CSC). The welding current remains at this level. Release the torch trigger and
the welding current drops to the pre-defined welding current at the pre-defined
slope-down speed (SLO). Press the torch trigger and the welding current drops to
the pre-defined crater end current (CEC) at the pre-defined slope-down speed
(SLO). Release the torch trigger and the arc is extinguished. The shielding gas
continues to flow for the set time (PoG).
) on the middle display and the wire diameter (e.g. 1.0 mm) on the right-hand display. You
2
inoMIG 350/400/500
BA-0014 • 2020-06-05