Jackle JESS WELDING inoMIG 350 Betriebsanleitung Seite 75

inoMIG 350/400/500
Pos.
M
N
O
P
Q
9.1.2 MC2 control system
Fig. 15
A
B
C
D
E
Pos.
A
B
C
D
E
F
G
H
I
J
BA-0014 • 2020-06-05
Description
Fx operating button for setting welding functions (e.g. for throttle strength, tap for less than
0.5 seconds) or options (e.g., for remote control, press for more than 1 second)
LED indicator for the units % or seconds if these values are shown in the middle display
Operating button for switching between 2-step, 4-step, 2-step spot and crater filling (tap)
LED indicator showing whether 2-step, 4-step, 2-step spot or 2T/4T crater filling is active
Display of wire speed in m/min (HAND-9) or adjustment of the arc length in the range −3.0 V to
+3.0 V (AUTO-9), flashing dot: HOLD function active
MC2 control box
Welding voltage display F
Welding current display G Operating button for operating
LED indicator for material
strength, water flow H LED indicator for operating mode
I
Welding parameters operating
J
button
Operating button for gas test
O
N
M
L
K
J
I
Description
Display for the welding voltage in volts, flashing dot: HOLD function
Display for the welding current in amperes or the material thickness, as well as the throttle, creep
speed and wire burnback time
LED indicator for display of creep speed, wire burnback time, material thickness or welding
current
Operating button for switching between throttle strength, creep speed, wire burnback time,
material thickness, and welding current (spot time if spot welding is activated)
Operating button for activating the gas test or, in setup mode, for increasing the values for
throttle, creep speed, wire burnback time, material thickness, and power (LED (C) flashing)
Operating button for activating the wire feed-in function or, in setup mode, for reducing the
values for throttle, creep speed, wire burnback time, material thickness, and power (LED (C)
flashing)
Mode operating button for switching between MIG, electrode and TIG operating modes
LED indicator for active operating mode (MIG, electrode or TIG)
LED indicator, HAND/AUTO (MANUAL/AUTOMATIC) mode
Operating button for material selection (tap for less than 0.5 seconds) or select manual (HAND)
or automatic (AUTO) mode (press for more than 1 second)
Operating button for wire feed K
L
mode selection
M Operating button for operating
Manual/automatic LED indicator
N LED indicator for operating mode
Operating button for material
O Wire speed, arc length display
selection
9 Operation
Welding power knob
Knob for material type, material
strength, wire speed, arc length
mode selection
A
B
C
D
E
F
G
H
EN - 21