Bluetooth Setup [Bt]; Pair Mode [Btp] - Canton Smart Soundbar 9 Bedienungsanleitung

English
The Soundbar 9 uses the following radio channels:
• 5.2GHz Band: 5.2G-1 = 5180MHz
• 5.8GHz Band: 5.8G-1 = 5736MHz
To set the radio channel of the wireless audio module to a fix channel or to automatic selection please do as follows:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu Wireless Setup [WIS] and confirm with the "OK" button.
2
Use the " " or " " button to select the item RF Channel [CHN] and confirm with "OK".
3
Select the desired channel number (see above) using the "+" or "–" key and confirm your selection by pressing "OK".
4
Press the "M" button to exit this menu item.
5

Bluetooth Setup [BT]

At this menu you can set all features relating to the Bluetooth
The Bluetooth Setup menu includes four submenus, as follows:
BT Pairing [BTP]
This menu allows you to set whether the Soundbar 9 sends a pairing request to (mobile) devices permanently at the mode Auto [AUT], or
whether this has to be done manually via the Bluetooth
avoid unwanted pairings.
To change the way in which the paring process is initiated please proceed as follows:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate to the menu Wireless Setup [WIS] and confirm with the "OK" button.
2
Use the " " or " " button to select the menu item Bluetooth Setup [BT] and confirm with the "OK" button.
3
Select the menu item Pair Mode [BTP] and confirm with the "OK" button.
4
Select the desired parameter [MAN] resp. [AUT] using the "+" or "-" key, then press the"OK" button, again.
5
Press the "M" button to exit this menu item.
6
Notes: • If a signal is being transmitted via Bluetooth® wireless technology, the Soundbar 9 does not send a pairing request to a second
(mobile) device, even if the automatic mode Auto [AUT] is selected.
• If the input Bluetooth is not selected, neither automatic nor manual pairing is possible. To achieve pairing independent of the
selected input, the BT Select [BTS] function must be set to automatic (please refer to the next chapter).
92
5.2G-2 = 5210MHz 5.2G-3 = 5240MHz
5.8G-2 = 5762MHz 5.8G-3 = 5814MHz
wireless technology module integrated into the Smart Soundbar 9.
®
pairing button on the remote control when using the mode Manual [MAN] to
®