Wireless Reset [Wre]; Bluetooth® Setup [Bt]; Pairing Mode [Btp] - Canton Smart Soundbox 3 Bedienungsanleitung

English

Wireless Reset [WRE]

With this function you can reset the wireless module of the speaker, which is used to connect wireless speakers to the Soundbox 3.
Caution: ALL settings and wireless speakers stored on the wireless module will be deleted.
To perform the reset, proceed as follows:
Power up the speaker by pressing the Power key " ".
1
Enter the menu by pressing and holding the input select key "
2
Press the "+" or "-" key until Wireless Setup [WIS] is indicated in the Display.
3
Press the Play/Pause button " ". The display shows [WSP].
4
Press the "+" or "-" key until Wireless Reset [WRE] is indicated in the Display.
5
Press the Play/Pause button " ". The display shows [NO].
6
Note: To cancel the reset procedure press the input select key "
to exit the menu.
To execute the reset, press the "+" key. The display flashes [YES] for approx. 5 seconds.
7
Then the display shows [OK] to confirm the reset procedure.
8
After that the speaker enters normal operation modus.
9
Bluetooth® Setup [BT]
At this menu you can set all features relating to the Bluetooth® wireless technology module integrated into your Soundbox 3. The Setup
menu includes four submenus, as follows:

Pairing Mode [BTP]

This menu allows you to set whether the speaker sends a pairing request to (mobile) devices. In factory setting the speaker sends
permanently a pairing request [AUT]. If you want to avoid unwanted pairing processes of (mobile) devices you can sett it to manually
[MAN]. By setting manually [MAN] you can only activated the request by pressing the "Bluetooth Pairing" button only on the optional
remote control.
76
" for at least 3 seconds. The display shows [SPS].
". The display shows [WIS], again. Press this key twice