Canton Smart Soundbar 9 Bedienungsanleitung Seite 101

Problem Possible cause
Playback of the The automatic playback function Autoplay [APL]
Bluetooth device is activated (ON).
®
starts automatically
when the speaker is
switched on.
Pairing of wireless 1. The slave speaker was not disconnected or
speakers fails. was not disconnected from the mains long
enough before pairing.
2. The slave speaker was in standby mode
during the pairing.
3. The slave was connected to the mains before
the pairing was initialised on the Soundbar
(master speaker).
4. The distance between slave and master is too
high.
Two speakers play the 1. Two slave speakers were assigned the same
same channel. channel when pairing.
Solution
Set the Autoplay [APL] function to OFF.
1. Disconnect the slave speaker to be paired for
at least 30 seconds from the mains.
2. After turning on the power switch of the slave speaker
resp. connecting it to the mains, power it up by the remote
control.
3. Always start pairing at the Soundbar before connecting the
slave to the mains.
4. Reduce the distance between Soundbar and slave speaker.
The maximum distance is 10 m in the same room.
1. First use the test tone to check which speaker is playing
the wrong channel. Reconnect this speaker as described
in WSP (Wireless Speaker Pairing) and select the correct
channel.
English
3 1 01