Lipsync [Lip]; Max Volume [Vol] - Canton Smart Soundbar 9 Bedienungsanleitung

English

Lipsync [LIP]

The processing of video data in the TV or a videoprojector usually takes longer than the audio signal processing. Lipsync [LIP] allows you to
take corrective action when the sound out of the Soundbar 9 is not lip-synchronous with the image on the TV. The delay of the audio signal
reproduced by the speakers can be set from 0 to max. 80ms, in steps of 10ms. 10ms (Milliseconds) = 0.01seconds.
For this, proceed as follows:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
2
Use the " " or " " button to select the menu item Lipsync [LIP] and confirm with the "OK" button.
3
Change the delay time using the "+" or "-" key to a desired value and confirm with the "OK" button.
4
To exit the menu, press the Menu button "M".
5
Note: Because of wirelessly connected speakers the maximum possible delay may be lower than 80ms.

Max Volume [VOL]

You can limit the maximum settable volume with this (protective) function Max Volume in such a way that the sound level (indicated in the
speaker's display) can not be turned up above the set value. You can set the desired volume level from 0 to 70, where 70 represents the maxi-
mum.
This function does not limit the output volume level of the Soundbar 9 to a certain level but only the selectable volume.
Note:
Based on the incoming signal (level) the output volume can be higher or lower.
To change the maximum volume, do the following:
To enter the Menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
2
Use the " " or " " button to select the menu
3
Change the volume level between values between 1 and 70 using the "+" or "-" key. Then press "OK", again.
4
To exit the menu, press the Menu button "M".
5
86
item Max Volume and confirm with the "OK" button.