Standby Mode [Stb] - Canton Smart Soundbar 9 Bedienungsanleitung

English

Standby Mode [STB]

This function controls, how the Soundbar 9 powers up resp. down – manually or automatically, partly dependent on an incoming audio signal.
The Soundbar 9 supports the following fuctions:
• ECO [ECO]: If ECO is selected, the Soundbar enters standby mode after 20 minutes without any detected audio signal at the selected
input and needs to be powered up manually using the remote control.
• Network [NSB]: If Network [NSB] or LSB [LSB] is selected, the Soundbar must be turned on manually and will automatically enter stand-
by after 20 minutes without detected audio at the selected input. However, there is a difference to the ECO mode, as described below.
Network [NSB] is available only when the network port [NWS] in the Network Setup menu is set to Wireless (WLA). When set to Wired
[ETH], only the LSB [LSB] standby mode is available. Network [NSB] is the default setting of the Soundbar 9.
• Auto [AUT]: If Auto is selected, the Soundbar turns on automatically if an audio signal is detected at any input. If no signal is detected
any longer, the Soundbar enters standby mode after 1 minute (at the digital inputs Optical, Coaxial, and Bluetooth) resp. 15 minutes (at
the analogue input Line [AUX]).
• Manuell [MAN]: If Manual is selected, the Soundbar stays active permanently and must be powered up and down manually, using the
remote control.
If ECO is selected, all wirelessly connected speakers will be powered down automatically, but each speaker must be powered up individually.
This is the operation mode with the lowest standby power consumption. All the other modes Network, LSB, Auto, and Manual provide an
automatic power up function for all wirelessly connected speakers when powering up the Smart Soundbar 9 (Master Device).
You can find additional information in the description in the "Sub output" and "Wireless speaker pairing" part.
Notes: •If the standby mode is set to Auto [AUT] and the Soundbar is set to standby mode using the "ON/Standby" key of the remote
control, it is not possible for the Soundbar to switch on automatically. To use the Auto mode of the Soundbar as intended, do not
power down the Soundbar using the On/Standby key but always wait until the Soundbar powers down, automatically.
•To avoid an unintentional power-up of the Soundbar using the analogue input, the threshold value has been set quite high. To make
sure the Soundbar 9 powers up correctly, please set the output level of your analog audio source to a high level (but not more than
2Vrms).
To set the standby mode, please do the following:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
2
Choose the function Standby Mode [STB] using the
3
Use the "+" or "-" button to select select the wanted Standby mode and confirm with the "OK" button.
4
82
" " or " " button and confirm with the "OK" button.