Troubleshooting - Canton Smart Soundbar 9 Bedienungsanleitung

Troubleshooting

Please find attached an overview of the most common problems. If you have further questions, please contact your Canton dealer,
contact our service hotline at Tel. + 49 (0) 6083 287-0 or send us an e-mail to info@Canton.de.
Problem Possible cause
Soundbar 9 does not 1. Protective film not removed.
respond to the remote
2. The battery is empty .
control.
No sound. 1. Sound format of the source device
2. There is no signal from the player.
3. Cable not connected correctly / defective
cable.
Sound reproduction 1. Volume of the Soundbar 9 or the source de-
too soft.
2. The max. possible volume was limited by
Soundbar 9 does not Mains cable not connected to power outlet
turn on. and / or Soundbar 9.
selected is incorrectly.
vice is set too low.
means of the "Volume" function (VOL).
Solution
1. Remove the protective film on the remote control.
2. Replace the battery, make sure the polarity is
correct when inserting.
1. Please check the correct setting of your source device.
2. Unlock the digital output on the source device, the
volume control might be set to "zero" and must be
increased (please refer to the manual of the device).
3.1. Check the connection between the player and the
Soundbar 9 and replace the cable if necessary.
3.2. Make sure that the protective caps on the connectors
of the optical cable are removed.
1. Increase the volume with the "Volume" button.
Increase the volume of the source device.
2. Increase the max. possible volume according
to instructions.
Establish connection.
English
3 9 7