Canton Smart Soundbar 9 Bedienungsanleitung Seite 103

Problem Possible cause
The volume is In the Max Volume [VOL] menu, a maximum
limited to a value volume less than 70 was selected.
less than 70.
A speaker shows 1. The slave speaker is operated
WLS in the display. without the Soundbar.
2. The slave speaker is not paired yet.
The subwoofer does 1. The subwoofer is not paired yet.
not reproduce sound.
2. The subwoofer is connected to the Soundbar
using a RCA cable, but Sub Out is set to Off(not
activated.
No connection can be 1. The DHCP server is deactivated in the router.
established between
the router and the
2. A filter for MAC addresses was created in the
Soundbar.
router.
3. Your router is not compatible with Chromecast
built-in.
Your WLAN network 1. The network connection for the Soundbar is
is not displayed during set to Ethernet [ETH].
setup.
The Soundbar is not 2. Device and Soundbar must be conncted to the
indicated in the app same network.
on your (mobile)
device.
Solution
Increase the value according to
chapter Max. Volume [VOL].
1. Turn on the Soundbar.
2. Pair the slave speaker with the Soundbar according
to chapter WSP.
1. Pair the slave speaker with the Soundbar according
to chapter WSP (Wireless Speaker Pairing).
2. Activate the output Sub Out (ON) at the Sub Out menu.
1. Activate the DHCP server of the router according to the
router's instructions.
2. Deactivate the MAC Address Filter.
3. Routers that are demonstrably compatible can be found in
the web link in the chapter "Using Chromecast built-in for
audio". However, there are more compatible routers.
1. Change the setting to WiFi [WIF].
2. Connect device resp. Soundbar to the corresponding net-
work (e.g. when using a guest network)
English
3 1 03