Ir Clear [Clr] - Canton Smart Soundbar 9 Bedienungsanleitung

English
To learn the relating IR codes, hold the TV / third party remote control in position and do the following steps:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
2
Select the IR Menu [IRM] and press the "OK" button to confirm.
3
Choose the function Direct Input Learn [DIL] and press the "OK" button to confirm.
4
The OSD shows "Press the new button" and [HD1] is flashing on the display and [BDP] is displayed on the screen for the first HDMI
5
input. You can now assign the [HD1] input to a button on your TV remote control.
Note: If you press this key on the remote control while the Soundbar 9 is in normal mode, the system switches directly to the HD1 (BDP)
input.
Press the desired key on the remote control. If the infrared code has been successfully stored by the system, [OK] is shown briefly in
6
the display resp. "Success" on the screen, followed by the next input.
If the code could not be learned, [FAI] appears briefly on the display resp. FAIL appears on the screen to indicate that no code has
7
been stored. In this case, [HD1] will still be displayed. In this case the system jumps back into the IR Menu to the item Direct Input
Learn [DIL]. Please increase or decrease the distance between the Soundbar 9 and the TV-/Universal remote and repeat the process.
Alternatively you can try to press the buttons of the TV-/universal remote longer or less long.
If you do not want to assign a button to input HD1, you can select the next input (in this case HD2) by pressing the " " button.
8
The " " button takes you to the previous input.
If you do not press any button on the TV remote control within 15 seconds, the system returns to the IR Menu.
9
The BT input is the last entry in the list. By pressing the " " key again, the system jumps back to the IR menu.
10
Note: Due to the variety of infrared codes it is not possible to guarantee that every IR remote control signal can be learned by the
Soundbar 9. Signals from radio frequency (RF) remote controls cannot be learned, generally!

IR Clear [CLR]

With this function you can delete all IR codes stored on the Soundbar 9 in case you do not want the Soundbar to react to the IR codes of
your TV / third party remote control any longer.
To delete the IR commands learned by the Soundbar 9, please do the following:
To enter the Menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
2
80