Sub Phase [Pha] - Canton Smart Soundbar 9 Bedienungsanleitung

• Connecting a wireless subwoofer from the Canton Smart-series using a signal cable: As an alternative to the wireless audio transmission,
you can connect your subwoofer with a signal cable, so that the audio data is transmitted over the RCA cable and the control commands
are transmitted wirelessly. This way, the Smart subwoofer can be used like a "normal" subwoofer, but will still be controlled and adjusted
by the Soundbar 9. To do so, please set the option to "Wireless [WLS]" after you have successfully paired a Smart subwoofer according to
chapter "Wireless Speaker Pairing [WS].
To enable the subwoofer output [WRD] or [WLS] resp. disable the output [OFF], please do the following:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
2
Select the menu item Sub Out and confirm with the "OK" button.
3
Change the setting Wired [WRD] or Off[OFF], in case Wireless [WLS] using the +/- keys and confirm your selection with "OK".
4
To leave the menu, press the menu-button "M".
5

Sub Phase [PHA]

Use the function Sub Phase to change the phasing of a connected (Smart) subwoofer between 0 degree and 180 degree (phase inverted) re-
lative to the Soundbar 9. Try a phasing of 180 degree in case the bass level at the selected crossover frequency (80 Hz) seems to be much too
low or completely off. Dependend on the position of the Soundbar 9 and the subwoofer, phase cancellation may occur around the crossover
frequency. In most cases these phase cancellations can be avoided with a 180 degree shifted (inverted) subwoofer audio signal. This function
works for both, wirelessly and wired subwoofers.
Note: This parameter is only available if a wireless subwoofer is connected to the Soundbar 9 or if Sub Out is set to Wired [WRD].
Otherwise this menu item is grayed out.
To set the subwoofer's phase to 180 degree resp. back to 0 degree, please do the following:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
2
Use the " " or " " button select the menu item Sub Phase [PHA] and confirm with the "OK" button.
3
Change the setting using the "+" or "-" key between 0 degree [0] and 180 degree [180] and confirm with the "OK" button.
4
To exit the menu, press the Menu button "M".
5
English
3 8 5