Rf Power [Txp]; Rf Channel [Chn] - Canton Smart Soundbar 9 Bedienungsanleitung

If [FAI] appears in the display, repeat steps 4 – 7 and make sure that...
8
a.) the desired slave speaker was disconnected from the mains for at least 30 seconds.
b.) not more than 30 seconds have been passed between pressing the OK button and witching on the slave speaker.
c.) the distance between the two speakers (soundbar and slave speaker) may not exceed 10 m and they are in the same room.
To pair a further speaker resp. a subwoofer, please repeat steps 4 – 7.
9
Caution: Should you have performed the above steps, never repeat them with the Soundbar 9 (master speaker) switched off, as this will
automatically designate a new master speaker and would prevent the previous slave speakers from connecting to the previously
designated Soundbar 9.

RF Power [TXP]

The wireless audio module of the Soundbar 9 is by default set to 25% of the maximum transmission power [ECO], according to -6dB. In most
cases this is completely adequate for a stable and non-interrupted wireless connection with Smart speakers and/or a Smart subwoofer in the
same room. In case of connection problems and/or audio dropouts you can increase the transmission power. At Medium setting [MED] the
transmission power is at 50% (-3dB) and at Max at 100% (0dB).
To adjust the transmission power of the wireless audio module please do as follows:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu Wireless Setup [WIS] and confirm with the "OK" button.
2
Use the " " or " " button to select the item RF Power [TXP] and confirm with "OK".
3
Select the desired transmission power using the "+" or "–" key and confirm your selection by pressing "OK".
4
ECO = 25% (-6dB)
Press the "M" button to exit this menu item.
5

RF Channel [CHN]

Usually the wireless audio module of the Soundbar 9 choses a free radio channel in the 5.2GHz resp. 5.8GHz band automatically (AUTO /
[AUT]). In case you use your WiFi in the 5GHz band too and dropouts in the audio transmission occur, this gives you the option to set the
radio frequency of the wireless audio module to a specific channel.
If you select a different specific channel for your WiFi-router too, interferences and dropouts should no longer occur.
The selected frequency for the Soundbar 9 and the router should ideally be as far apart as possible.
Medium = 50% (-3dB) Max = 100% (0dB).
English
3 9 1