Hdmi Cec [Cec] - Canton Smart Soundbar 9 Bedienungsanleitung

Use the " " or " " button to select the IR Menu [IRM] and confirm with the "OK" button.
3
Choose the function IR Clear [CLR] and press OK. The OSD shows the IR Clear menu and "No" is selected. The display indicates
4
[NO].
To cancel the operation, press the "M" key or press "OK".
5
To delete stored codes please use the " " button to select "Reset All", the display shows [YES]. Please press "OK" to delete the
6
codes.
The screen will display "Please Wait" for 3 seconds. The system will then return to the IR menu. The display confirmes the deletion by
7
showing [CLR].

HDMI CEC [CEC]

Consumer Electronics Control is a cross-market standardized protocol for controlling devices connected to the HDMI® inputs/outputs. The
device is supplied with this function deactivated (OFF). The CEC functions supported by the Smart Soundbar 9 are:
- One touch Play: By pressing the "Play" button of the Blu-Ray player the Soundbar switches on automatically and changes to the
corresponding HDMI® input.
- System Standby: With the TV switched on, when you return it to standby mode by pressing the "Power" key the Soundbar 9 also goes
automatically into standby mode.
Note: Depending on the programming of the TV device, the Soundbar 9 can also be automatically activated with the
TV.
- Volume/Mute: The volume of the Soundbar 9 can be operated using the Mute and Volume buttons of the TV remote control.
Notes: • Many device manufacturers have developed their own protocols for controlling their devices based on the CEC standard. This can
mean that the functions described above only function partially, or do not function at all.
• In order to avoid conflicts when controlling the Smart Soundbar 9, the "Volume +/–", "Mute" and "Power" buttons on the TV
remote control should not be learned through the IR learn function of the Soundbar when using the CEC function. Delete the codes
where necessary.
To activate/deactivate this function, proceed with the following steps:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
2
Use the " " or " " button to choose the function HDMI CEC [CEC] and confirm with the "OK" button.
3
Use the "+" or "-" button to select [OFF] to disable the CEC functionality resp. [ON] to enable it and confirm with the "OK" button.
4
Press the "M" button to exit this menu item.
5
English
3 8 1