Input Select [Sel]; Sub Out [Sub] - Canton Smart Soundbar 9 Bedienungsanleitung

English

Input Select [SEL]

If the Input Select function is set to Auto [AUT], the system automatically changes the optical, coaxial, analogue and BT input as soon as the
signal disappears at the currently selected signal input and an input signal is detected at one of the Soundbar's inputs mentioned before.
If Manual [MAN] is selected, the inputs must be selected manually via the remote control using the " " or " " button.
By default this function is deactivated.
To change the Input Select function from Manual [MAN] to Auto [AUT] or contrary, proceed as follows:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
2
Use the " " or " " button to select the menu item Input Select [SEL] and confirm with the "OK" button.
3
Change the setting using the "+/-" keys and confirm with the "OK" button.
4
Press the "M" button to exit this menu item.
5
• The input NET is always selected automatically in case of an incoming audio signal!
Notes:
• If you want the HDMI® inputs to be switched automatically too, please activate the HDMI® CEC function in the same-named
menu.
• To automatically switch from the optical or coaxial digital input to one of the other inputs, the source unit must be switched off.
For analogue Line and Bluetooth® stopping playback is sufficient.
Sub Output [SUB]
The Soundbar 9 has a build-in subwoofer. Therefore the function Sub Output [SUB] is deactivated ([OFF]) by default. To expand the frequen-
cy range and to enhance low level frequency reproduction the Soundbar 9 can be extended with an external subwoofer. You can integrate an
additional subwoofer in the following ways:
• Connecting an active subwoofer using an RCA cable: If you set the function "Sub Out" to wired [WRD], you can connect your active
subwoofer to the SUB OUT on the rear of the Soundbar 9 using a cinch-RCA-cable. In this case the internal subwoofer of the Soundbar
will automatically be limitied to 80 Hz and frequencies below 80 Hz will be routed to the external subwoofer.
• Pairing a wireless subwoofer from Canton Smart-series: The Soundbar 9 has a build-in wireless transmitter that can stream audio and
control commands wirelessly from the Soundbar to paired wireless speakers and/or subwoofers from the Canton Smart-series within your
room. In case you have paired a wireless subwoofer in the menu "Wireless Setup [WIS] / Speaker Pairing [WSP], the option "Wireless
[WLS]" will additionaly be available in the "Sub Output" menu. This means, that the connected subwofer gets the audio as well as the
control commands (state, volume, etc.) wirelessly.
84