Direct Input Learn [Dil] - Canton Smart Soundbar 9 Bedienungsanleitung

Select the IR Menu [IRM] and press the "OK" button to confirm.
3
Choose the function IR Learn [IRL] and press the "OK" button to confirm.
4
IRL is flashing in the display. On the screen "Press the key you want to learn" is displayed.
5
Press the wanted function on the Canton remote control e.g. "+" for Volume +.
6
Now the display shows the chosen function, e.g. "V+".
7
Within 15 seconds, press the key you wish to allocate to this function on the TV remote.
8
Once the IR command has been successfully allocated, the display shows [OK] resp. the OSD shows "Success" and you can continue
9
with the programming of the next key function, e.g. "Volume –".
If the display shows [FAI] the allocation has failed and you need to repeat steps 4 to 7. Please try a lower or higher distance between
8
the speaker and the TV remote control in case the process fails again. Alternatively, try to press the key on the TV remote shorter or
longer.
To exit the IR Learn menu, press and hold the "M" button for 3 seconds. After one minute without input, the system automatically
9
returns to the IR menu.
Notes: • The red "On/Standby" key on the remote control has a dual function. Press it once and the display shows ON which allows the
switching on function to be programmed. If the red "On/Standby" key on the Canton remote control is pressed twice in quick
sequence, the display shows STB and the Standby resp. switching off function can be learned. If your TV remote control has
only one key for the "On" and "Off" functions, both the "On" and "Standby" functions must still be allocated with this
command.
• Due to the variety of infrared codes it is not possible to guarantee that every IR remote control signal can be learned by the
Soundbar 9. Signals from radio frequency (RF) remote controls cannot be learned, in general!

Direct Input Learn [DIL]

This function allows the user a direct selection of the signal inputs if using a third party remote control. In addition to the INPUT UP( )
and INPUT DOWN( ) function, you can directly select the signal inputs (e.g. ARC) when using your TV or universal remote control. That
means you can allocate the desired input to a key on your remote control.
Learnable inputs: HDMI input 1-3 [HD1-HD3], HDMI
®
network input [NET] and Bluetooth
output [ARC], optical input [OPT], coxial input [COA], analogue input [AUX],
®
input [BT]
®
English
3 7 9