Led Indications; Display Indications - Canton Smart Soundbar 9 Bedienungsanleitung

English

LED indications

The LED indicates the following conditions:
• LED off (not illuminated)
• LED shining red
• LED flashing green quickly
• LED shining green
-------------------------------------------------------------------------------------------------------------
• LED flashing green slowly
• LED flashing green
• LED flashing green/red
• LED flashing green two times

Display indications

On-Screen Display (OSD)
All settings and configurations of the Soundbar 9 can comfortably be done using the on-screen-display with your TV-Screen. To do so the
Soundbar must be connected with your TV using a HDMI
the remote guides you to the main menu.
Note:To change the language of the OSD (German or English), navigate to the main menu by pressing the menu button "M". Select the
menu System Setup [SYS] by using the arrow buttons " " or " " and enter by pressing the "OK" button. Use the arrow buttons " " or " " to
select the menu item Sprache [LAN] and confirm by pressing the "OK" button. Use the "+" or "-" button to select the desired language as
German [DEU] or English [ENG] and confirm your selection with the "OK" button. Exit the menu by pressing and hold the menu-button "M".
LED Display
The blue LED display is located on the front of the Soundbar 9 and lights up for five seconds after a command. The most important display
indications and their meaning are listed here:
66
Soundbar disconnected from the mains
Soundbar in standby mode
Soundbar is booting
Soundbar is active (network connected)
Network disconnected
Network setting mode
Soundbar is executing a FW update
Ethernet setup mode (LAN connected)
-cable. The menu is comprehensibly structured. Pressing the menu button (M) on
®