Network Setup [Nws]; Network Select [Nwc] - Canton Smart Soundbar 9 Bedienungsanleitung

English
To perform the reset please do as follows:
Power up your Soundbar 9 by pressing the Power button " " on the remote.
1
To enter the menu, press the "M" button.
2
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
3
Use the " " or " " button to select the function Factory Reset [RES] and confirm with the "OK" button. The OSD shows the menu Fac-
4
tory Reset and "No" is selected, the display shows [NO].
If you want to cancel the reset precedure, press "OK", or press the menu key "M".
5
If you want to perform the reset, select "Reset all" using
6
The OSD shows "Please Wait", the display still shows [YES]. After about 10 seconds the Soundbar 9 turns off and starts up again.
7
During the starting process the LED flashes green rapidly.

3. Network Setup [NWS]

The third menu item of the Main Menu includes the Setup of the network connection. It contains the two items:
• Network Connect [NWC]
• Network Reset [NWR]
Network Connection [NWC]
At this menu the connection way of the WiFi module is set. The module can be connected Wireless [WLA] or Wired [ETH] using the Ethernet
port of the Smart Soundbar 9.
To change the connection way from wireless to wired or contrary, do the following:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu Network Setup [NWS] and confirm with the "OK" button.
2
Confirm the first item Network Select [NWC] with the "OK" button.
3
Select the desired connection way using the "+" or "-" key, [WIF] for a wireless resp. [ETH] for a wired network connection and confirm
4
with the "OK" button.
Press the "M" button to exit this menu item.
5
88
" " or " " key and press "OK". The display shows [YES].