Canton Smart Soundbar 9 Bedienungsanleitung Seite 100

English
Problem
The BT input cannot
be selected via the
"Input" buttons.
The Soundbar 9 does
not automatically
switch to the BT input.
No playback via
Bluetooth wireless
®
technology.
100
Possible cause
The function BT Select [BTS] is activated.
1. The BT Select function is deactivated (MAN).
2. Bluetooth ® is disabled on your device.
3. The Soundbar 9 is connected to
another device.
4. The device is not paired with
the Soundbar 9.
1. There is no connection between the Soundbar
9 and the (mobile) device.
2. The (mobile) device is paired,
but it does not play.
3. You are out of reach (max. 10 m).
Solution
The switching happens in this case automatically as soon as
the Soundbar 9 detects an audio signal from the device.
If unwanted, set BT Select (BTS) to manual.
1. Activate the BTS function (AUT).
2. Activate Bluetooth ® on your device.
3. Disable Bluetooth on the other device.
®
4. Pair your device with the Soundbar 9.
1. Connect the (mobile) device as described.
2.1. The (mobile) device needs to be reconnected.
2.2. Set the volume on the (mobile) device to the
maximum possible value.
2.3. Increase the volume of the Soundbar 9.
2.4. Make sure that sources of interference, such as a
WiFi router or a laptop, are not placed in close proximity
to the Soundbar 9.
2.5. Simultaneous operation via WiFi and Bluetooth
connection from a (mobile) device is not possible
without interference in some cases; therefore, disable
WiFi on the device.
3. Reduce the distance between the Soundbar
and the (mobile) device.
®