Wireless Pairing [Wsp] - Canton Smart Soundbar 9 Bedienungsanleitung

English

Wireless Pairing [WSP]

The Soundbar 9 offers you the ability to connect (wireless-)speaker from the Canton Smart Series wirelessly to build multichannel home cine-
ma system with a range of possibilities. With the build-in audio wireless module you can, for example, connect two surround speakers and/or
a wireless subwoofer. With the wireless module you can upgrade the Soundbar 9 to a full 4.1 home cinema system.
The pairing of wireless-speakers is made in the Wireless Speaker Pairing [WSP] menu. In such a wireless speaker setup, the Soundbar is always
the "master speaker", other speakers will be defined as "slave speakers".
Caution: Before starting the pairing process, the speaker to be paired (slave speaker) must have been disconnected from the mains for at least
30 seconds.
For pairing slave speakers, proceed as follows:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu Wireless Setup [WIS] and confirm with the "OK" button.
2
Select the function Wireless Pairing [WSP] and confirm with the "OK" button.
3
Surround Left [SL] is selected. Please confirm the front left speaker or use the
4
and confirm with "OK".
The following speakers are selectable:
• Surr. Left und Surr. Right: The paired surround speaker will play the surround channels of a multichannel signal, instead of being
played as virtual speakers from the Soundbar.
• Subwoofer: If a subwoofer has been paired, the lower frequencies will not be played by the Soundbar anymore, but by the
subwoofer. In case of pairing a Canton Smart subwoofer the crossover frequency is adjusted automatically to the optimal
You can find additional information in the description in the "Sub output" and "Wireless speaker pairing" part.
Now select the speaker you want to pair and press "OK" to start the pairing process.
5
The Status indication should change to Pairing and the LED display indicates [PIR].
Connect the (slave) speaker you want to pair to the mains and – if applicable – switch this speaker on at the power switch.
6
If the speaker is in stand by mode, turn it on by pressing the power button on the remote control.
Caution: The maximum time between pressing the OK button and turning on the slave speaker is 30 seconds.
Approx. 10 – 20 seconds after switching on the slave speaker the displays should show [CON] resp. "Connected" at the OSD. From now
7
on the display of the (slave-)speaker and the display of the Soundbar 9 are in sync.
90
" " or " " buttons to select the speaker you want to pair
value.