Distance [Dst]; Speaker Eq [Eq] - Canton Smart Soundbar 9 Bedienungsanleitung

English
frequency band. Therefore, adjust the Subwoofer value to your preferred level.
To exit the menu item, press the "M". The test tone generator will be deactivated automatically.
10
Note: Speakers marked as "Virtual" are physically not available. The corresponding channel is generated by the physically available spea-
kers and therefore the gain is only "virtually" adjusted.
Speaker Distance [DST]
An adjustment of the distance between the speakers and listening position is needed for a perfect spatial effect, especially in case of mul-
tichannel input signals. Measure and enter the distance between the speakers and your listening position. The distance is adjustable between
0.0m and 9.9m, in steps of 0.1m, where 3.0m is the factory setting.
To adjust the distance please do as follows:
To enter the menu, press the "M" button.
1
Enter the first menu item Speaker Setup [SPS] and press "OK".
2
Enter the menu item Distance [DST] using the
3
Select the speaker that you want to adjust the distance of by using the " " or " " button and press "OK".
4
All deactivated speakers are greyed out and cannot be adjusted.
You can find additional information in the description in the "Sub output" and "Wireless speaker pairing" part.
You can adjust the distance by using the "+" and "–" buttons. To go back to the speaker list press the "OK" button.
5
Press the "M" button to exit this menu item.
6
Speaker EQ (Equalizer)
The Equalizer menu allows you to select three different equalizers for the Soundbar or the front left and right speakers [FLR], surround left and
right [SLR], as well as the subwoofer [SUB] to match the room conditions. Only physically available speakers are displayed.
To change the equalizer settings do the following:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu Speaker Setup [SPS] and press the "OK" button to confirm.
2
Select the menu Speaker EQ (Equalizer) and confirm with the "OK" button.
4
Use the "+" or "-" button to select desired loudspeakers and confirm with the "OK" button.
5
Change the EQ using the "+" or "-" button.
5
• EQ1 for floor level installation (factory setting).
76
" " or " " button and confirm with the "OK" button.