Network Setup [Nws]; Network Connection [Nwc]; Network Reset [Nwr] - Canton Smart Soundbox 3 Bedienungsanleitung

3. Network Setup [NWS]

The third menu item of the Main Menu is the Setup of the WiFi Network. It contains the two items:

Network Connection [NWC]

1

Network Reset [NWR]

2
Network Connection [NWC]
At this menu the connection way of the WiFi module is set. The module can be connected wirelessly [WIF] or wired [ETH] using the Ethernet port at the
Soundbox 3. To change the connection way from wireless to wired and vice versa, proceed as follows:
To enter the Menu, press and hold the input select key "
1
Use the "+" or "-" button to navigate into the menu Network Setup [NWS] and confirm with the Play/Pause button " "
2
Select the item Network Connection [NWC] and confirm with the Play/Pause button " ".
3
The display shows the current setting [WIF] respectively [ETH].
4
If you want to keep the setting, press the input select key "
5
To change the setting, press the "+" or "-" key.
6
After 3 seconds the display shows [OK] and the speaker reboots.
7
Note: If the Soundbox 3 was already connected to a wireless network and then switched to Ethernet [ETH], it automatically switches back to WLAN [WIF]
if no network cable is connected.
Network Reset [NWR]
This function is to reset all network settings stored on the Soundbox 3.
Caution: All settings you have made and stored on the speaker's WiFi module will be deleted.
To perform the reset, proceed as follows:
Power up the speaker by pressing the Power-button " ".
1
Enter the menu by pressing and holding the input select key "
2
Press the "+" or "-" key until Network Setup [NWS] is indicated in the display.
3
Press the key Play/Pause button " ". The display shows [NWC].
4
Press the "+" or "-" key, and Network Reset [NWR] is indicated in the Display.
5
" for at least 3 seconds.
" to exit this menu item.
" for at least 3 seconds. The display shows [SPS].
English
3 7 3