Turning Bluetooth On The Prosthesis On/Off - Ottobock Genium X3 3B5-3 Gebrauchsanweisung

Parameter
Basic flex.
Gain
Basic ext.
Locking angle
Pitch
Volume

8.3 Turning Bluetooth on the prosthesis on/off

INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the Cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (function
only available in basic mode) or by connecting/disconnecting the battery charger. Bluetooth is
then turned on for approx. 2 minutes. During this time, the app must be started and used to
establish a connection. If required, Bluetooth on the prosthesis can be switched on permanently
afterwards (see Page 80).
INFORMATION
Basic mode (mode 1) has to be active to turn off Bluetooth. If a MyMode is activated, one has to
switch to basic mode to turn off Bluetooth.
80
Adjustment Setting
software range, app
range
0–200 +/- 20
0–100 +/- 10
0–60 +/- 20
0–90 +/- 10
1000 Hz– 1000 Hz–
4000 Hz 4000 Hz
0–4 0–4
Meaning
Level of flexion resistance at the start
of flexing the knee joint
Increase in flexion resistance (starting
with the parameter "Basic flex.")
when flexing the knee joint. The knee
joint locks at a certain flexion angle,
which depends on the setting of the
parameters "Basic flex." and "Gain".
Level of extension resistance
Angle up to which the knee joint can
be extended.
Information: If this parameter is >0,
the knee joint is locked in a flexed
position in the extension direction. To
unlock it, unload the prosthesis and
tilt it back for at least 1.5 seconds.
This makes extension of the joint pos­
sible independently of the settings for
the parameters "Basic ext." and
"Locking angle". This may be neces­
sary to switch to basic mode using a
movement pattern.
Pitch of beep signal for confirmation
tones
Volume of beep signal for confirma­
tion tones (e.g. when checking the
charge level, switching MyModes).
The "0" setting deactivates the aud­
ible feedback signals. However, warn­
ing signals in case of errors are still
generated.