Overview Of Adjustment Parameters In Mymodes; Turning Bluetooth On The Prosthesis On/Off - Ottobock Genium 3B1-2 Gebrauchsanweisung

Use
Parameter
Stance function
Sitting function
Stair Function
Pitch
Volume
In addition to the parameters, the remote control (optional accessory) can also be used to activate deep sleep
mode. Further information on deep sleep mode (see Page 84).

9.3.3 Overview of adjustment parameters in MyModes

The parameters in the MyModes describe the static behaviour of the prosthesis for a specific motion pattern such
as cross-country skiing. Damping behaviour is not automatically controlled and adjusted in MyModes.
The following parameters can be modified in the MyModes (except MyMode "Brake knee"):
Parameter
Gain
Pitch
Volume
The following parameters can be modified in MyMode "Brake knee":
Parameter
Stance function
Pitch
Volume

9.4 Turning Bluetooth on the prosthesis on/off

INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the Cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down or by connecting/discon­
necting the Bluetooth battery charger. Bluetooth is then turned on for approx. 2 minutes. During this time, the app
must be started and used to establish a connection. If required, Bluetooth on the prosthesis can be switched on
permanently afterwards (see Page 82).
82 | Ottobock
Adjustment soft­ App/remote
ware range control adjust­
ment range
Deactivated 0 - deactivated
Activated 1 - activated
Deactivated 0 - deactivated
Activated 1 - activated
Deactivated 0 - deactivated
Activated 1 - activated
1000 Hz – 1000 Hz
4000 Hz 4000 Hz
0 – 4 0 – 4
Adjustment soft­ App/remote
ware range control adjust­
ment range
0 – 100 +/- 10
1000 Hz – 1000 Hz
4000 Hz 4000 Hz
0 – 4 0 – 4
Adjustment soft­ App/remote
ware range control adjust­
ment range
0 – 180 +/- 20
1000 Hz – 1000 Hz
4000 Hz 4000 Hz
0 – 4 0 – 4
Meaning
Activation/deactivation of the stance function.
For switching with the Cockpit app or remote
control, this function has to be activated in
the adjustment software. Further information
(see Page 74
).
Activation/deactivation of the sitting function.
For switching with the Cockpit app or remote
control, this function has to be activated in
the adjustment software. Further information
(see Page 76).
Activating/deactivating the stair and obstacle
function. For switching with the Cockpit app
or remote control, this function has to be
activated in the adjustment software. Further
information (see Page 76)
– Pitch of beep signal for confirmation tones
Volume of beep signal for confirmation tones
Meaning
Value for speed at which flexion resistance
increases as the knee angle increases
– Pitch of beep signal for confirmation tones
Volume of beep signal for confirmation tones
Meaning
Basic resistance for the knee joint without
load
– Pitch of beep signal for confirmation tones
Volume of beep signal for confirmation tones
Genium 3B1-2/3B1-2=ST