Overview Of Adjustment Parameters In Mymodes; Turning Bluetooth On The Prosthesis On/Off; Switching Bluetooth Off/On Using The Cockpit App - Ottobock C-Leg 3C88-3 Gebrauchsanweisung

Parameter
Stance function
Sitting function
Volume

8.3.3 Overview of adjustment parameters in MyModes

The parameters in the MyModes describe the static behaviour of the prosthesis for a specific
motion pattern such as cross-country skiing. Damping behaviour is not automatically controlled
and adjusted in MyModes.
The following parameters can be modified in MyModes:
Parameter
Gain
Volume

8.4 Turning Bluetooth on the prosthesis on/off

INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down or by
connecting/disconnecting the battery charger. Bluetooth is then turned on for approx. 2
minutes. During this time, the app must be started and used to establish a connection. If
required, Bluetooth on the prosthesis can be switched on permanently afterwards (see
Page 60).

8.4.1 Switching Bluetooth off/on using the cockpit app

Switching off Bluetooth
1) When the component is connected, tap the symbol in the main menu.
→ The navigation menu opens.
2) In the navigation menu, tap the entry "Functions".
3) Tap the entry "Deactivate Bluetooth".
4) Follow the on-screen instructions.
Switching on Bluetooth
1) Rotate the component or connect/disconnect the battery charger.
→ Bluetooth is switched on for approx. 2 minutes. During this time, the app must be started
in order to establish a connection to the component.
2) Follow the on-screen instructions.
60 | Ottobock
Adjustment App/remote
software control
range adjustment
range
0 - deactivated
1 - activated
0 - deactivated
1 - activated
0 to 4 0 to 4
Adjustment App/remote
software control
range adjustment
range
0 to 100 +/- 10
0 — 4 0 — 4
Meaning
Activation/deactivation of the stance
function. This function needs to be
enabled in the adjustment software.
Activation/deactivation of the sitting
function. This function needs to be
enabled in the adjustment software.
Volume of beep signal for confirma­
tion tones.
Meaning
Value for speed at which flexion resist­
ance increases as the knee angle
increases
Volume of beep signal for confirma­
tion tones.