Loco Addresses; Setting Loco Addresses - FLEISCHMANN TWIN-CENTER 6802 Handbuch

6802_10_12_04_Handbuch_GB
The Controller Knob
The controller knob will alter the speed of the loco
and its direction. On turning the knob, one will
feel a slight click, each of which corresponds to
exactly one speed level. By endless rotation of
the knob, without end stop, when changing
locos, the TWIN-CENTER will automatically take
the stored speed setting of the newly selected
loco.
The Display
The large background illuminated LCD display
will indicate to you the exact running situation at
any time.
Data Format
Speed
Individually indicated at each side is the indicati-
on of each controller of the data format, loco
addresses, speed and direction of the locomotive
currently under control.
Information about the chosen operation mode is
displayed in the centre.
7.2

Loco Addresses

The individual locomotives of a digital control
system are called up by their so-called addres-
ses. By keying in a specific numerical sequence,
the individual decoder built into each loco will
then recognise it.
Each decoder will only react to its own specific
address, so that only that particular loco with that
address can be spoken to.
7.2.1

Setting Loco Addresses

If any vehicle is to be operated by the TWIN-CEN-
TER, then it must be called up under its own
decoder address.
01.03.2007
Loco Address Keyboard Status
Direction
13:57 Uhr Seite 107
The address will be entered by pressing the [lok#]
key. The cursor will blink in the corresponding
address area in the display, indicating that it is
waiting for a loco address.
There are then several ways of proceeding.
Input via the numeric keyboard
• Pressing the [lok#] key
(if not already done).
• Enter the sequence of numbers for the
loco address via the numeric keyboard
in the centre operating area of the
TWIN-CENTER (12 is shown)
• End the address input by
- pressing the [↵] key to confirm
- pressing another key [f1] [f2] [f3] [f4]
[function] [off] [lok#]
- rotating the control knob
- changing the direction (press control
knob)
Input using the controller
• Pressing the [lok#] key
(if not already done)
• Setting the loco address via the control
knob of the relevant controller. Procee-
ding from the loco address currently on
display, by turning the control knob to
the right the value for the loco addres-
ses will count upwards, or by turning the
knob to the left, they will count down-
ward. By rotating the knob gently the
addresses will count in 1 per each click
stop, or by rotating it faster also in tens
or hundreds
• End the address input by
- pressing the [↵] key to confirm
- pressing another key [f1] [f2] [f3] [f4]
]function] [off] [lok#]
- changing the direction (press control
knob)
TIP
Erroneous entries can be cancelled by
pressing the [C] key. If the whole address
is cancelled using the [C] key, so that no
numbers remain showing in the address
area, by further pressing the [C] key
again, the old address before the address
change will be called up once more.
7 The Controller
107