Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6802_10_12_04_Handbuch_GB
10 Programming Mode
10.3 Menu Structure
"Programming"
The following menu items are available:
> FMZ
> DCC
10.4 Programming of
FMZ-Decoders
The sub-menu "FMZ" serves to programm, or
likewise, read the different FMZ- and TWIN-deco-
ders which are available.
10.4.1 Reading the Decoder Address
Using the menu item "read" the addresses of all
of the previously available FMZ- and similarly
TWIN-DECODERs can be read. This includes
equally decoders which are electronically codea-
ble as well as decoders with which the address
has been set by using coding paint. If no address
is discernable, then the corresponding error infor-
mation will be displayed.
And here is how to do it:
• Press the [mode] key until the indication
"Programming Mode" appears in the
display, alternatively the keys [mode] and
[4] (see chapter 8.2).
• Press the [menu] key
• Using the [↓] key, search through until
the entry "FMZ" is found
• Further with the [→] key
• Using the [↓] key, search through until
the entry "Read" is found
• Start the search with the [↵] key
The sought after address will appear in
the display
• Return to operation with the [menu] key
126
01.03.2007
= Read
> Address Progr.
> Extended Prog.
> Register Prog.
> CV-Prog. (byte)
> CV-Prog. (bit)
> Paged Prog.
> Main line Prog.
> long Addresses
> Extended Prog.
13:58 Uhr
Seite 126
10.4.2 Programming the Addresses
FMZ-locos with electronically codeable addres-
ses and locos with TWIN-DECODER can have a
new address 1 - 119 programmed by the TWIN-
CENTER.
And here is how to do it:
• Press the [mode] key until the indication
"Programming Mode" appears in the
display, alternatively the keys [mode] and
[4] (see chapter 8.2).
• Press the [menu] key
• Search through with the [↓] key until the
entry "FMZ" is found
• Proceed with the [→] key
• Using the [↓] key, search through until
the entry "Address Progr." is found
• Further with the [→] key
• Enter the FMZ-address from 1-119
• Start the programming procedure with
the [↵] key
Successful programming will be indica-
ted in the display
• Return to operation with the [menu] key
There are FMZ-locos with unalterable addresses.
These cannot be reprogrammed electronically.
10.4.3 Additional Programming
On the TWIN-DECODER it is possible to program
additional parameters besides the address.
These are the minimum and maximum running
speeds as well as the so-called control characte-
ristics (control characteristic curves), i.e the style
and manner, in which steps the speed between
the minimum and maximum speed will be affec-
ted by the controller.
The minimum speed can be set to be between
1% and 99% of the maximum possible speed.
The maximum speed can be set to be between
2% and 100% of the maximum possible speed.
If the maximum speed is entered as less then the
minimum speed then an error indicator will appe-
ar. The entry will not be accepted.
Three types of control characteristic curves
"SKL" can be selected:
Werbung
Kapitel
Inhaltsverzeichnis
