FLEISCHMANN TWIN-CENTER 6802 Handbuch Seite 146

6802_10_12_04_Handbuch_GB
Supplement A1
The following section describes the special func-
tions. These are functions which workwise can be
controlled or similarly set from your TWIN-CEN-
TER or your TWIN-CONTROL.
A few special options are valid for the TWIN-
CENTER and for the TWIN-CONTROL as well,
and can be set from either piece of equipment,
whilst other special options are only valid for the
TWIN-CENTER. The valid equipment is shown
against each special option.
And here is how to do it:
• Press the [menu] key
• Press the [mode] key
• Search through using the [↓] key until
the entry "special option" is found
• Further with the [→] key
NUMBER
OF THE SPE-
CIAL OPTION
25 TWIN-CENTER
With this special option, it can be determined whether the TWIN-CENTER can be
set for one or other digital formats to send a so-called Idle-Paket (Data paket for
syncronisation, without running commands)
0 = no general Idle-Paket generated.
1 = a general Idle-Paket will be generated for DCC (works setting).
8 = a general Idle-Paket will be generated for FMZ.
9 = 8 + 1: a general Idle-Paket for DCC and FMZ will be generated.
Attention: If a loco address is set for DCC-operation, then the special option 9 will
automatically be set.
27 TWIN-CENTER
Determines the time lapse following the last input command, until a loco address is
cancelled from the refresh cycle (= data compression)
0 = no data compression
1 - 240 = time in minutes from the last input command up to data compression
(works setting = 10 minutes).
28 TWIN-CENTER
Determines the conditions for data compression
= 0 loco speed = 0 (works setting)
= 1 loco speed ≠ 0
33 TWIN-CENTER
To control the transmissions of point commands via the PC bus
0 = Point commands will not be transmitted
1 = Point commands will be transmitted via the I2C bus of the TWIN-CENTER
146
01.03.2007 13:58 Uhr
• At the first input position, enter the iden-
• Using the [→] key, move the cursor to
• Enter the perameter value of the relevant
• Press the [↵] key. A '*' is shown in the
• Return to operation with the [menu] key
PARAMETER VALUE OF THE SPECIAL FUNCTION
Seite 146
Special Option:
N. ..1 = ---
tification number of the special option
after the "Nr"
the right hand input position
special function
display, to show that the special option
is activated
ADVICE
The setting of the special functions as
delivered, can be dispensed with by the
[C] key in the right hand column.