The Twin-Control; Common Information; Connection; Technical Data - FLEISCHMANN TWIN-CENTER 6802 Handbuch

6802_10_12_04_Handbuch_GB
After a configuration reset, the TWIN-CENTER
has the following settings:
Speed level indication: direct display
Controller:
Loco data format:
Power:
Programming track:
Data rate:
Syntax:
Computer:
Special options:
Loco Data Format
All loco entries and format settings will be can-
celled.
Points (electrical accessories) setting
The entries for the individual electrical accesso-
ries which have been made via the option "virtual
address" (chapter 8.1) will be cancelled. At the
same time all point routes will be cancelled as
they no longer valid, having no allocations.
And here is how to do it:
• Press the [menu] key
• Press the [mode] key
• Search through using the [↓] key until
the entry "Reset" is found
• Continue with the [→] key
• Search through using the [↓] key until
the desired entry is found
• Continue with the [→] key
• Search through using the [↓] key until
the entry "yes"
• Confirm the selection using the [↵] key
• Return to running with the [menu] key
15

The TWIN-CONTROL

15.1 Common Information

The TWIN-CONTROL is an add-on controller for
the TWIN-CENTER. It extends the functions of
the TWIN-CENTER with another 2 control knobs,
keyboard, memo and s88 monitor.
All running operations and switching functions
of the TWIN-CENTER can also be carried out
by the TWIN-CONTROL.
01.03.2007 13:58 Uhr
14 Basic Settings
DC-controller
DCC 14
(basic setting format)
HO power
automatic
2400 bit/s
LocoNet-Syntax
PC
Take back all alterations
Seite 141
15 The TWIN-CONTROL
•
Important
A direct connection to the programming
track with all its settings which are the
responsibility of the TWIN-CENTER is not
possible.

15.1.1 Connection

The TWIN-CONTROL is not fed with power from
its own transformer, but it receives its energy from
the LocoNet. The first TWIN-CONTROL is linked
into the TWIN-CENTER using the LocoNet-cable
included with it. Plug in the cable into the TWIN-
CENTER in the socket LocoNet T, and into the
LocoNet T
will then always be connected via a vacant socket
on the TWIN-CONTROL or other equipment
connected via the LocoNet.
The advantage of the LocoNet is the possible
cable length of up to 100 m. In this way your
TWIN-CONTROLS can be positioned anywhere
around the layout.
Up to 6 TWIN-CONTROLS can be driven by one
LocoNet connection.

15.1.2 Technical Data

Connection
Current consumption
on the LocoNet
Size

15.2 Display, Keys and Menu

Displays, keys and menu you will recognise from
your TWIN-CENTER. In the operation and indica-
tion, there is no difference between TWIN-CON-
TROL and TWIN-CENTER. The information can
be referred to in chapter 6 of the manual.
TWIN-CONTROL simi-
larly using either of the
two LocoNet sockets
on the rear of the
equipment. Every addi-
tional TWIN-CONTROL
Onto the LocoNet
max. 120 mA
180 x 136 x 80 mm
141