The Connections Of The Twin-Center; Connecting Up The Transformer, Trackwork And Programming Track - FLEISCHMANN TWIN-CENTER 6802 Handbuch

6802_10_12_04_Handbuch_GB

4 The connections of the TWIN-CENTER

4 The Connections of the
TWIN-CENTER
The connections for the TWIN-CENTER are
described below, and what you need to look out
for when connecting in the individual pieces of
equipment.
The picture in the front fold-out section shows the
rear of the TWIN-CENTER with all its connections
and their meanings. You will also find sockets on
both the right and left sides of the TWIN-CENTER
into which other pieces of equipment can be
connected, which are compatible with I
The TWIN-CENTER includes two plug-in connec-
tors with clamp-style connections for wiring in the
transformer, tracks, programming track and
DCC-booster.
The 6-pole plug connector
Using a small screwdriver (2mm wide) inserted
through the upper opening of the connector and
pushing gently, the clamp will open up. Insert the
uninsulated, carefully twisted end of the wire from
the front side holes. Release the screwdriver and
the wire will be securely fixed into its position to
give a secure contact.
Wire up the transformer, trackwork and similarly
the programming track using the enclosed wires,
according to the colour coded description
(shown below).
4.1 Connecting up the
transformer, trackwork and
programming track
The connections for the transformer, trackwork
and programming track are made by the 6-pole
clamp plug into socket 1.
98
01.03.2007 13:57 Uhr
The arrangement of the clamp plug (with coloured
wires) is shown below (as seen from the rear):
Programming Track
2 C-Bus.
1
2
3
4
5
6
Transformer
You will need a transformer with a power output
of at least 45 VA. If you are going to start off with
just a few locos only, and do not intend to run
them all at the same time, then you could use the
DIGITAL CONTROL transformer 6811. If you want
to use the full capability of the TWIN-CENTER,
the you should use the FLEISCHMANN transfor-
mer 6812 with its power output of 75VA.
The transformer power feed is connected into
clamps 5 (black) and 6 (yellow) of the 6-pole
clamp plug for socket 1.
Seite 98
Running Track
violet-white
violet
1 2 3 4 5 6
Programming Track (violet)
Programming Track (violet-white)
Digital Power Track connection to the
front rail (violet-whiteß)
Digital Power Track connection to the
rear rail (violet)
Common A.C. power feed from
transformer (black)
A.C. power feed from transformer (yellow)
IMPORTANT
Before switching on the transformer,
you must make sure that the connec-
tions for the transformer and track are
in the right sockets of the plug. An
incorrect polarity or mixing of the
wires could completely destroy the
equipment.
violet-white
violet
black
yellow
to trans-
former ->