Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

6802_10_12_04_Handbuch_GB

Quick Entry

1
Running
This shortened section gives you the possibility to
run a digital loco.
Important
Please read through the complete manual
in order to be able to use and understand
all the functions of the equipment.
Requirements
• TWIN-CENTER 6802 (with V1.100 softw.)
• TRANSFORMER 6812 or 6811
• FLEISCHMANN-Loco with Digital Deco-
der (FMZ / TWIN)
Connecting the wires to the clip-in Plug
• Rear rail onto clamp 4 (violet)
• Front rail onto clamp 3 (violet-white)
• AC Power from transformer onto
clamp 5 (black) and 6 (yellow)
IMPORTANT
Before you turn the transformer on,
please make sure that the connections
of the transformer and track are in the
correct outputs of the plug. The wires
should not be spliced together in case
of possible interference with each
other. A wrong connection or cross-
feed could destroy the equipment.
• Once completed, then insert the clip-in
plug into socket 1 of the TWIN-CENTER;
a comprehensive description of the
connections can be found in chapter 4.
Equipment connection
• Plug in the mains plug of the transformer
into the 230 V mains
• After a delay of 5 seconds, the red LED
on the top right hand side of the front
01.03.2007
13:57 Uhr
Running
Call up a Loco
Running a Loco
Changing the Direction
The 6-pole clamp
with the coloured
wires
Switching the Lights on or off
See chapter 7 for comprehensive description.
6812
Seite 89
panel will light up, indicating that the
TWIN-CENTER is ready for operation
• Press the [go] key. The green LED
now lights up, and the red LED will
go out
The TWIN-CENTER is ready to go
• Press [lok#]-key on the right or left
hand side of the controller
• Use the numerical keyboard to input
the desired address
• Conclude the sequence by pressing
the [↵] key
• The desired speed can be set by
rotating the control knob
• Rotate the control knob to zero,
wait for a short time (about
1 second) and then rotate the knob
again in the same direction.
• The [function] key turns the lights on
• The [off] key turns the lights off.
FMZ
Violet
Violet-white
clamp 4
clamp 3
Black clamp 5
Yellow clamp 6
TRAFO
6802
230 V
Quick Entry
DCC
TWIN-CENTER
89

Werbung

Kapitel

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Twin-control 6822

Inhaltsverzeichnis