Menu Item "Start Mode - FLEISCHMANN TWIN-CENTER 6802 Handbuch

6802_10_12_04_Handbuch_GB
7 The Controller
ADVICE
Function decoders can be operated using
the keys [f1] to [f4] of the corresponding
controller.
For some DCC-decoders, the functions f5 to f8
can be accessed by using the [lok#] key.

7.15 Menu Item "Start Mode"

As delivered, "auto. + Speed" are pre-set.
Once you have finished running the layout, all the
data is stored by the TWIN-CENTER. Under the
menu item "start mode", all the information requi-
red for the next running session can be entered.
No loco data
No data from previous running sessions will be
used.
Auto, Speed = 0
All locos used, including double heading, in the
previous running session will be used with their
same direction and their special functions as
before.
Auto + Speed*
Question whether to recreate the speed set-
ting (new with V1.100)
If you have set the start-up mode of your TWIN-
CENTER according to chapter 7.14 and likewise
chapter 14.13, so that when switching on, the
speed of the vehicles as you last used them will
be recreated (auto.+Geschw.*), then this will con-
tinue to be the case: all vehicles will set themsel-
ves in motion according to the last settings befo-
re the switching off.
Using special option SO827 it is now possible to
have a safety question built in after switching on
the equipment again. Here you will be asked
once more, whether you really wish to recreate all
the speed settings according to the last operati-
on before you switched off.
SO827=0 - no additional safety question (works
setting)
SO827=1 - additional safety question turned on
118
01.03.2007 13:58 Uhr
And here is how to do it:
(With software version V1.000 only the following
is possible:
Auto + Speed* (V1.000)
As well as the data of direction and special func-
tions, the speed of all locos will be used.
In which case, the complete operations as when
last switched off will be used again.
And here is how to do it (V1.000):
Seite 118
Restore loco
speed? yes
• With the [↵] key recreate the loco speed
Or alternatively:
• Using the keys [+] and likewise [↓]
change the setting "yes" or "no"
• With the [↵] key - take over no loco
speed
NOTE
• Press the [menu] key
• Press the [mode] key
• Search through using the [↓] key until
the entry "loco start mode" is found
• Further with the [→] key
• Using the [↓] key search through until
the desired entry is found
• Confirm the input with the [↵] key
• Return to operation with the [menu] key)