Point Setting; Virtual Addresses; Switching Time; Hand Controller - FLEISCHMANN TWIN-CENTER 6802 Handbuch

6802_10_12_04_Handbuch_GB
Factory setting: DCC
Comprehensive description shown in chapter 7.8

14.4 Point setting

14.4.1 Virtual addresses

So that a point / signal can be changed via an
electrical accessory receiver module, the point /
signal must first be allocated a virtual address.
This virtual address can be selected from 1 to
2000. They are then arranged in this menu with
the digital address of the receiver module and the
number of the output to which they are connec-
ted.
The input consists of the virtual address VAdd,
the digital address of the receiver module DAdd
and the output number Aus and the data format
DF of the receiver module.
Factory setting: none
Comprehensive description shown in chapter 8.1

14.4.2 Switching time

A definite period of time is required to carry out
the action of an electrical accessory. The mini-
mum and the maximum switching times are sett-
able in this menu.
Factory setting: min = 0.05 sec., max = 0.05 sec.
Comprehensive description shown in chapter 8.5

14.5 Hand Controller

14.5.1 Allocation of hand controller
to a TWIN-BOX
A hand controller must be connected into the
TWIN-CENTER/ CONTROL via a TWIN-BOX
intermediary. Therefore the entry for a hand con-
troller is C-Nr. (number from 1 – 16), the TWIN-
BOX number TwBox (number from 1 – 16) and the
TWIN-BOX ports (A, B, C, or D).
Comprehensive description shown in chapter 7.11

14.5.2 TWIN-BOX

In this menu, the function of the hand controller
switches of all hand controllers allocated to one
TWIN-BOX can be pre-set. It is made up from the
number of the TWIN-BOX (number from 1-16),
the number of the switch of the hand controller (1
01.03.2007 13:58 Uhr Seite 139
14 Basic Settings
or 2) and the function of the switch. Possible set-
tings: loco specific emergency stop, common
emergency stop, function (light on light off) or
f1.
Factory setting: Loco specific emergency stop
Comprehensive description shown in chapter
7.11

14.6 Display

In this menu the brightness and contrast of the
display can be altered by using the keys [+] and
[↓].
Comprehensive description shown in chapter
6.3.5
14.7 Power of the Track Network
The power on the trackwork can be limited to
18V. Possible settings: HO-operation without li-
mitation or N operation with power limited to
18 V.
Factory setting: HO operation
When setting the power, then the corresponding
power of the booster is also set.
Power for HO operation
The output power is not controlled and according
to the consumption will give up to 24 V top power
with an input power from the transformer of 18 V.
This is the setting recommended for HO and lar-
ger scales.
Power for N operation
The output power is limited to a top power of
18 V.
And here is how to do it:
• Press the [menu] key
• Press the [mode] key
• Search though using the [↓] until the
entry "Power" is reached
• Continue with the [→] key
• Search through using the [↓] key until
the desired entry is found
• Confirm the selection with the [↵] key
• Return to running with the [menu] key
139