The Controller; Operation Components - FLEISCHMANN TWIN-CENTER 6802 Handbuch

6802_10_12_04_Handbuch_GB

7 The Controller

7 The Controller
The TWIN-CENTER has two inbuilt controllers
which are completely independent from each
other. They can be found located on the left and
right hand sides of the operating unit. Locomoti-
ves can be called up and controlled from either
controller.
Simultaneously digital decoders with different
data formats (FMZ, TWIN and DCC according to
the NMRA standard) can be controlled and ope-
rated.
The controllers will work even whilst the pro-
gramming or whilst the settings are changed.
7.1

Operation Components

The front of the TWIN-CENTER
The following elements will operate with both
controllers:
The [go] key
The power to the main trackwork and onto any
sections of track connected to the connected
booster will be switched on by operating the [go]
key. This key can be operated from either con-
troller.
The [stop] key
The power to the main trackwork and onto any
sections of track connected to the connected
booster will be switched off by operating the
[stop] key. In the display "emergency stop" will
be shown. This key can be operated from either
controller.
106
01.03.2007 13:57 Uhr
The keys [f1] [f2] [f3] [f4]
The functions of these keys are dependant upon
whether the relevant controller is running an FMZ-
loco or another digital loco. Whilst in DCC opera-
tion, these keys will operate special functions,
like special lighting, horn or smoke generator, the
meanings of them on FMZ- or TWIN/FMZ-opera-
tion are as follows:
[f1]
[f2]
[f3]
[f4]
The [function] and [off] key
They serve to switch the loco lighting on or off.
The [lok#] key
Initiates the input process for a loco address.
An initially called loc decoder address is automa-
tically assigned to the FMZ data format. Locos
equipped with DCC-decoder have to be assigned
to the DCC data format as described in chapter
7.8.
On some DCC-decoders, the functions f5 to f8
can be accessed by first pressing the [lok#] key
and then the function key [f1, f2, f3 or f4] (see
chapter 7.4).
Seite 106
ADVICE
If the keys [go] and [stop] are operated
simultaneously for around two seconds,
then the TWIN-CENTER will be reset to
its switched on mode (reset).
Special function
Setting the individual acceleration inertia
Loco or track precedence
(loco precedence is already pre-set)
Loco specific emergency stop with stor-
age of the desired speed
ADVICE
On some DCC-decoders, the functions f5
to f8 can be accessed in conjunction with
the [lok#] key (see chapter 7.4).