Setting Virtual Loco Addresses - Loco Numbers; Allocation Demands; Deleting A Virtual Address; Double Heading - FLEISCHMANN TWIN-CENTER 6802 Handbuch

6802_10_12_04_Handbuch_GB
Loco numbers are stored in the memory of the
TWIN-CENTER. If a virtual address is not going to
be used again, then it must be removed from the
memory.
Virtual loco addresses (loco numbers) can, just
like other addresses, also be used for double-
heading (see chapter 7.10).
7.9.2 Setting virtual loco addresses
– Loco Numbers –
• Press the [lok#] key
• Insert the decoder address
• Press the [↵] key
• Press the [lok#] key
• Press the [menu] key
• Using the [↓] key, search through until
the entry "Virt.Addr" is found
Loco Settings
=Virt.Addr . .221*
• Insert the numerical sequence for the
virtual address (loco number). Ideally,
addresses should reflect the class num-
ber or running number of the train.
ADVICE
The virtual addresses can be within an
area from 1 to 9999. They should not be
the same as the address of another loco
decoder in use.
• The address will be confirmed with the
[↵] key, and indicated with '*' at the end
of the row
• Press the [menu] key to return to opera-
tion
Now the virtual loco address (loco number) can
be called up just like a normal address and, in
addition to the decoder address, be used as well
in order to control the locomotive. It can just as
easily be used for double-heading. It will be indi-
cated in the display by '*' in front of the address
input.
01.03.2007 13:57 Uhr
7.9.3
The allocation between a virtual loco address and
the corresponding decoder address can be
shown by the TWIN-CENTER.
And here is how to do it:
7.9.4
A virtual address (loco number) can be deleted by
calling up the decoder under its decoder address
and deleting the entry in menu "Loco settings -
Virt. Addr." by using the [C] key and confirming
with the [↵] key.

7.10 Double Heading

Several locomotives can be run at once using one
controller of the TWIN-CENTER. One locomotive
can just as easily be used under its decoder
address as by its virtual address (loco number) to
make up double-heading.
In this so-called double-heading up to 4 locomo-
tives can be used in tandem. All together up to
eight different double-headings are possible.
Naturally it is sensible to make up double-hea-
ding using locomotives which are similar in their
performance: as a general rule, the same speed
level for one may not be the same as for another
because of its different gearing.

7.10.1 Setting up double heading

Seite 113
7 The Controller

Allocation Demands

• Choose the virtual address
(loco number)
• Press the [lok#] key
• Press the [menu] key
• In the display will appear for example
the following indication:

Deleting a virtual address

• Press the [lok#] key
• Insert the loco address
• Press the [↵] key
The loco now called up is the so-called
"basis-loco"
113