Software; Problems And Solutions - FLEISCHMANN TWIN-CENTER 6802 Handbuch

6802_10_12_04_Handbuch_GB
17 Tips · 18 Software · 19 Problems and Solutions
gue power. How to set the decoder for solely digi-
tal operation will be described in the instructions
of the relevant decoder.
For some newer types of decoder, the program-
ming for sole digital operation can be achieved, in
that the Bit #2 of the configuration variable CV
#29 is set to zero. Please note, however, that this
is not possible for all DCC-decoders.
On simple decoders there is no possibility to
solve this problem.
18

Software

Under this menu item, you will find the serial
number of your TWIN-CENTER and the version
number of the software.
And here is how to do it:
• Press the [menu] key
• Press the [mode] key
• Search through using the [↓] key until
the entry "software-vers." is found
• Further with the [→] key
• The upper row will show the version
number of the software. The lower row
shows the serial number of the TWIN-
CENTER
• Return to operation with the [menu] key-
The system software of the TWIN-CEN-
TER or TWIN-CONTROL can be upda-
ted at any time using the computer inter-
face of the TWIN-CENTER.
Information regarding an update will be available
in good time.
19

Problems and Solutions

Fault: The TWIN-CENTER will not
switch on.
Cause: The TWIN-CENTER has not input
power.
Solution: Examine the plug on the transformer
or the clamps on socket 1 of the
144
01.03.2007 13:58 Uhr
Fault:
Cause:
Solution:
Fault:
Cause:
Solution:
Fault:
Cause:
Seite 144
TWIN-CENTER.
Check the connection between the
TWIN-CENTER and the transformer
or the mains connection to the trans-
former.
The TWIN-CENTER uses the
wrong language.
The incorrect language has been set
in the basic menu.
Switch the TWIN-CENTER off.
Switch the TWIN-CENTER on again
whilst you have pressed one of the
following keys:
1 German
2 English
3 French
4 Italian
5 Dutch
6 Swedish
7 Spanish
8 Portugese
The green LED lights up, but the
locos will not run.
If the TWIN-CENTER is switched on
with the [go] key but the locos will not
run and the points cannot be chan-
ged, then the connection between
the TWIN-CENTER and the track
must be interrupted. If the track is
connected via an external additional
booster, then it may be that the
connection between the TWIN-CEN-
TER and this booster may be inter-
rupted, or between the track and the
track output of this booster.
Examine the connections leading to
the track on socket 1 of the TWIN-
CENTER and the connections on the
track itself. Examine the connection
cable to the external booster. For a
booster connected into socket 2,
check to ensure that the flat cable
band is connected in the correct
position and firmly in the socket.
The red LED over the [stop] key
always blinks after a short running
session.
The TWIN-CENTER is continuously