Syntax; Computer - FLEISCHMANN TWIN-CENTER 6802 Handbuch

6802_10_12_04_Handbuch_GB
11 The Computer-Interface
• Using the [↓] key search through until
the entry "Bit per second"
• Further with the [→] key
• Using the [↓] key search through until
the desired entry is found
• Confirm the input with the [↵] key
• Return to operation with the [menu] key

11.1.2 Syntax

If the TWIN-CENTER is operated via a Computer
(PC or MAC), the computer and the TWIN-CEN-
TER use e certain language, a so called "sytax" to
communicate with each other. You must adjust
the syntax depending on the computer program
you intend to use to control your layout.
The TWIN-CENTER operates with its own com-
mand sequence (TC-Syntax) as printed on next
page. This sequence includes commands which
are also used to control the FMZ-central unit
6800 via a computer.
In addition, the TWIN-CENTER also incorporates
as an alternative, the syntax of the Intellibox from
the firm of Uhlenbrock. These syntax can be used
for example, to create a PC control programm
which could not be done with FMZ. If you wish to
use these Syntax, then please contact the com-
pany for further information.
Solely TC-Syntax
Only the TC-Syntax will be used.
Solely IB-Syntax
Only the Intellibox- (IB) Syntax will be used.
Solely LocoNet-Syntax*
Only the LocoNet-Syntax will be used.
And here is how to do it:
• Press the [menu] key
• Press the [mode] key
• Search through using the [↓] key until
the entry "Interface" is found
• Further with the [→] key
• Using the [↓] key search through until
the "Syntax" entry is found
• Further with the [→] key
• Using the [↓] key, search through until
the desired Syntax is found
• Confirm the input with the [↵] key
• Return to operation with the [menu] key
132
01.03.2007 13:58 Uhr

11.1.3 Computer

As delivered "PC" is pre-set
The computer connector port must be set for the
computer to be used. The following are the co-
As delivered, "LocoNet-Syntax" is pre-set
ordinates:
PC-IBM compatible Personal Computer*
For technical users: If the "CTS" (clear to send)
command of the RS 232 connector port of the
TWIN-CENTER is activated, then there will be a
+12V power peg an the CTS connector of socket
8 to ensure the data carrier towards the TWIN-
CENTER.
MAC-Apple Macintosh Computer
For technical users: If the "CTS" (clear to send)
command of the RS 232 connector port of the
TWIN-CENTER is activated, then there will be a
-12 V power peg an the CTS connector of socket
8 to ensure the data carrier towards the TWIN-
CENTER.
Nothing
The interface is deactivated.
And here is how to do it:
• Press the [menu] key
• Press the [mode] key
• Search through using the [↓] key until
• Further with the [→] key
• Using the [↓] key search through until
• Further with the [→] key
• Using the [↓] key search through until
• Confirm the input with the [↵] key
• Return to operation with the [menu] key
Seite 132
the entry "Interface" is found
the entry "computer" is found
the desired entry is found