Switching Point Routes; Changing Point Route Groupings; Linking Up Routes Of Points - FLEISCHMANN TWIN-CENTER 6802 Handbuch

6802_10_12_04_Handbuch_GB
9 The Memo Mode to switch complete routes of points
9.2

Switching Point Routes

And here is how to do it:
• Press the [mode] key until the indication
"MemoryMode" appears in the display,
alternatively the keys [mode] and [2] (see
chapter 8.2).
The individual keys of the keyboard will
now no longer be allocated to individual
points, but each of the 16 keys can now
be allocated to a point route, just as you
programm it in.
• Simply pressing on one of the keys will
be sufficient and a whole point route
containing up to 10 separate steps will
be switched.
9.3 Changing Point
Route Groupings
The Memo mode is shown in the middle of the
display along with the input of the active group. It
will always be the same group which was last
active at the time of leaving the memo-mode the
last time.
Changing the group by entering a new group
number can be made by using the [menu] key.
And here is how to do it:
• Press the [mode] key until the indication
"Memory Mode" appears in the display,
alternatively the keys [mode] and [2] (see
chapter 8.2).
• Press the [menu] key
• In the left hand column of the display,
enter the desired point route group num-
ber (1 - 3) after the "Gr.-Nr."
• Confirm with the [↵] key
9.4

Linking up Routes of Points

The TWIN-CENTER can be used to link up point
routes together, i.e. one route can lead into an-
other. In this way, a route consisting of more than
10 switching steps can be called up with one
124
01.03.2007 13:58 Uhr
command. The linking command must be the last
command of a point route. Beyond that point, no
program steps will be executed. The building of
loops will be automatically detected and remo-
ved.
To link up point routes, then a four figure number
is entered instead of the virtual address of an
electrical accessory. This consists of the linking
indicator 9, the group number 1 -3 and the route
number 1 - 16.
And here is how to do it:
The speed of the operation of all point routes can
be changed using the special option 450 (in mul-
tiples of 50 ms: see supplement). The set time
allows a speed of 0.5 second per command. If
the operation time is shortened, please be aware
that the typical switching time of the electrical
accessory is not underestimated.
Seite 124
• Press the [mode] key until the indication
"Memory Mode" appears in the display,
alternatively the keys [mode] and [2] (see
chapter 8.2).
• In memo-mode, press the [menu] key
• In the left hand column of the display,
enter the desired point route group num-
ber (1 - 3) after the "Gr. Nr."
• Using the [→] key move to the right
hand side of the display to programming
"prog"
• To programm, press the [↵] key
• Enter the number of the route from
1 - 16 after "route nr."
• Press the [↵] key
• Under "step" enter the step number
• Use the [→] key to enter the deviation
• Under "VAdd" enter the deviation:
9+group+route (e.g. 9 2 04)
Gr 1 | Step VAdd RG
R13 | 6 9204
• Confirm using the [↵] key
• The cursor will jump now to "step"
• Start programming using the [←] key