Storing Of Double-Heading; Hand Controller Operation; Allocating A Hand Controller To A Twin-Box - FLEISCHMANN TWIN-CENTER 6802 Handbuch

6802_10_12_04_Handbuch_GB
7.10.3 Deleting of double-heading
A double-heading can either be completely dele-
ted or the locos can be individually "uncoupled".
And here is how to do it:
• Call up the double-heading via the
address of the basis-loco
(if not already carried out)
• Press the [lok#] key
• Press the [C] key
Consist:
remove all locos
• Using the [[↓] key search through for the
desired entry
• Confirm the choice by the [↵] key
• End with the [menu] key
ADVICE
In the menu to delete a double-heading,
the decoder addresses of the locomoti-
ves will appear in the display and not
those of the virtual addresses.

7.10.4 Storing of double-heading

Double-heading can be stored and therefore
used again if the start option of the TWIN-CEN-
TER is set to "auto" (see chapter 14.13).

7.11 Hand Controller Operation

The already well-known hand controller 6820 of
FMZ and the TWIN hand controller 6821 can natu-
rally also be used in conjunction with the TWIN-
TECHNIK. Those hand controllers are connected
to the TWIN-CENTER via TWIN-BOXES.
The hand controllers will be given virtual addres-
ses (hand controller numbers) which will later be
used in operation again linked in with the loco
address.
ADVICE
The hand controllers are able to generate
28 speed levels in each direction. A run-
ning commands for DCC-locos in 128
speed level mode are calculated automa-
tically.
01.03.2007 13:57 Uhr
7.11.1 Allocating a hand controller
The TWIN-BOXES are connected to the TWIN-
CENTER via the LocoNet. Each TWIN-BOX has a
four pole DIP-switch to set their individual
addresses on the LocoNet. The information to set
the DIP-switch is shown in supplement A4 and
similarly in the instructions with the TWIN-BOX.
Each TWIN-BOX has four connector ports for
hand controllers, and the hand controllers can be
plugged in at random. The ports are designated
A, B, C and D, in order to differentiate them easi-
ly from those of the electrical accessory receiver.
Ports of the TWIN-BOX can just as easily be left
vacant if desired.
The virtual address (hand controller number) of a
hand controller will be assigned in a menu of the
address of a TWIN-BOX together with a port.
And here is how to do it:
Seite 115
7 The Controller
to a TWIN-BOX
• Press the [menu] key
• Press the [mode] key
• Search through using the [↓] key until
the entry "Hand contr." is found
• Further with the [→] key
• Using the [↓] key search through until
the "Hand contr. No" entry is found
• Further with the [→] key
C-Nr. TwBox Port
.5 10
• In the first column under "C-Nr." input
the hand controller number from 1 to 16
• Further with the [→] key
• In the second column under "Twbox"
input the number of the TWIN-BOX from
1 to 16
• Further with the [→] key
• In the third column under "Port" with [+]
or [↓] select one of the connector ports
A-D
• Confirm the input with the [↵] key
• Return to operation with the [menu] key
A
115